DODmytro Oberemok

Dmytro Oberemok

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Dmytro Oberemok has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Impact of Different Parameters on the Efficiency of GaN/Porous-GaAs/GaAs Solar Cell

    by Alena Dyadenchuk, Serhii Halko, Tetiana Halko, Oleksandr Miroshnyk, Taras Shchur, Оleksandr Tobert, Mykhailo Tobert, Dmytro Oberemok, Paweł Kiełbasa

    Modern requirements for high-efficiency solar cells increase interest in the development of new materials and structures, in particular the use of GaN/porous-GaAs/GaAs composite materials and heterostructures, which allow to improve the efficiency and stability of solar energy conversion. To determine the photovoltaic characteristics of the GaN/porous-GaAs/GaAs photoconverter, a system of equations is used, including the Poisson equation, the diffusion equation, and the charge conservation equation. The simulation results of GaN/porous-GaAs/GaAs solar cells using PC1D software showed values of short-circuit current I SC = 33.2 mA, open-circuit voltage V OC = 1.022 V, fill factor FF = 83.4% and efficiency η = 28.3% In order to optimize the parameters of the solar cell, simulations were carried out with a change in the thickness of the GaN layer, the doping levels of the GaN and porous-GaAs layers. It was established that with a thickness of the GaN layer of 1.6 μm, the efficiency of the solar cell reaches a maximum value of 29.1%. The maximum efficiency was achieved when the GaN layer was doped with 1·10 17 cm −3 and was 28.4%. An increase in the temperature of the solar cell leads to a decrease in the open-circuit voltage and an increase in recombination losses, which is reflected in the decrease in the efficiency of the GaN/porous-GaAs/GaAs photoconverter from 29.8% at 270 K to 23.0% at 370 K.

  • Open Access

    Application of solar power plants and energy storage systems to balancing the power of electrical networks

    by Dmytro Oberemok, Oleksandr Miroshnyk, Oleksandr Moroz, Vitaliy Kamyshlov, Vitaliy Podobailo

    The modern development of renewable energy sources creates problems in balancing the power system. One of the effective solutions to this problem is the introduction of network energy storage systems based on batteries, which can be installed directly near consumers or at substations at load nodes. The advantages of such storage systems are modular structure, compactness, high functional flexibility, wide possibilities of control automation, as well as ease of integration into intelligent power networks. When studying the problem of balancing the power system under conditions of a significant share of renewable energy sources, it was found that the instability of their generation can be compensated by energy storage systems. Maintaining the balance of demand and generation is a necessary condition for ensuring reliable and stable operation of networks. Connecting powerful renewable energy sources can affect losses in power networks - usually electricity losses during transmission increase and its quality deteriorates. Therefore, these aspects should be carefully considered already at the stage of forming technical conditions in local electrical system. It is recommended that, in parallel with the construction of new renewable energy sources and energy storage systems, the relevant electrical networks be modernized with the introduction of intelligent technologies, bringing them closer to the “Smart Grid” concept. The main effect of introducing storage devices in networks is to ensure uninterrupted power supply to consumers who require increased reliability, to reduce electricity and power losses, to reduce investments in the development of generation and network infrastructure, to relieve networks of reactive power, to increase throughput and stabilize voltage at key nodes.

  • Open Access

    МОДЕЛЮВАННЯ СИСТЕМИ КЕРУВАННЯ MICROGRID У СЕРЕДОВИЩІ MATLAB/SIMULINK

    by Р. В. Оксенич, Д. О. Оберемок, О. Ю. Тоберт, О. О. Мірошник, С. В. Галько

    Використання сонячних фотоелектричних установок для електропостачання віддалених територій постійно зростає. Проте інтеграція таких джерел у мікромережі супроводжується проблемами, пов’язаними з їх нестабільністю та залежністю від погодних умов. Запропоновано модель мікромережі із вбудованою системою енергоменеджменту на основі методу прогнозного керування. Структура мікромережі включає фотоелектричну станцію та акумуляторну систему зберігання енергії, що дає змогу забезпечувати оптимальний розподіл генерації між джерелами та підвищувати надійність енергопостачання. Запропонований алгоритм прогнозного керування використовується для регулювання процесів заряджання та розряджання батареї з метою згладжування коливань сонячної генерації. Моделювання виконувалося на основі реальних статистичних профілів електроспоживання та даних про сонячну інсоляцію. У дослідженні враховувалися критичні сценарії роботи мікромережі: коливання навантаження, непостійність відновлюваної генерації та виникнення часткового затінення сонячних модулів.

  • Open Access

    ПРОБЛЕМИ ІНТЕГРАЦІЇ СОНЯЧНИХ ЕЛЕКТРОСТАНЦІЙ ТА СИСТЕМ ЗБЕРІГАННЯ ЕЛЕКТРОЕНЕРГІЇ У РОЗПОДІЛЬНІ МЕРЕЖІ

    by Д. О. Оберемок, Д. Г. Миргород, Р. В. Оксенич, О. Ю. Тоберт, С. В. Галько

    У статті досліджуються ключові проблеми та перспективи розвитку енергетичного сектору в умовах зростання споживання електроенергії та необхідності підвищення його стійкості. Особливу увагу приділено нестабільності генерації з відновлюваних джерел, зокрема сонячних та вітрових електростанцій, що зумовлює потребу у створенні резервних потужностей та впровадженні систем накопичення енергії.Розглянуто роль акумуляторних систем у балансуванні навантажень та підтриманні стабільності мережі, а також значення технологій Smart Grid для ефективного управління потоками енергії. Показано, що сонячні електростанції завдяки інверторам здатні не лише виробляти активну потужність, а й компенсувати реактивну, зменшуючи втрати та підвищуючи ефективність роботи електромереж. Зроблено висновок, що інтеграція інноваційних рішень, таких як системи накопичення, цифровізація управління та оптимізація виробництва, є важливою умовою підвищення надійності, економічності та екологічності сучасних енергетичних систем.