Seong-Sig Choi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Seong-Sig Choi has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Chang-Hyun Kim
Department of Advanced Mobility Components Group, Korea Institute of Industrial Technology, Daegu, South Korea
1 shared publication - Hak Yi
Department of Mechanical Engineering, Kyungpook National University, Daegu, Korea
1 shared publication - Hyoeun Kwon1 shared publication
- Jaehwan Kong
Department of Mechanical Engineering, Kyungpook National University, 80 Daehak-ro, Buk-gu, Daegu 41566, Republic of Korea
1 shared publication - Seung-Hwan Choi
Advanced Mechatronics Research Group, Daegyeong Division, Korea Institute of Industrial Technology, Daegu 42994, Republic of Korea
1 shared publication - Suwoong Lee
Department of Advanced Mobility Components Group, Korea Institute of Industrial Technology, Daegu, South Korea
1 shared publication
Latest Publications
- Open Access
Active-Assistive Control Based on Dynamic Moving Window for Trajectory Tracking of an Upper Limb Exoskeleton in Assisted Rehabilitation
Rehabilitation robotics faces the challenges of aligning engineering design with patient-specific needs. Most existing controllers in rehabilitation robots often constrain motion to fixed paths or provide only passive guidance, limiting user engagement and adaptability. This study proposes a novel active-assistive mode controller that integrates a virtual tunnel-based force generation mechanism with a dynamic moving-window technique for tracking activities of daily living (ADL) trajectories. Unlike conventional impedance controllers, the proposed method dynamically adjusts the virtual tunnel in real time, permitting voluntary upper-limb movement within a safe operational range while preventing excessive deviation. The system was implemented on a wearable two-degree-of-freedom (DOF) upper-limb exoskeleton equipped with drive and integrated sensor units. Experimental results demonstrated that decreasing the guidance force () increased tracking errors, from at 100% to at 30% , indicating greater voluntary participant motion. Peak actuator torques correspondingly decreased from 14.75 to 13.43 Nm (elbow) and from 4.14 to 2.48 Nm (wrist), confirming the controller’s capability to modulate robotic assistance according to user effort. Tests with 30 healthy participants demonstrated the effectiveness of guidance along predefined ADL trajectories, validating the controller’s potential for patient-centered rehabilitation.Open AccessActive-Assistive Control Based on Dynamic Moving Window for Trajectory Tracking of an Upper Limb Exoskeleton in Assisted Rehabilitation
Rehabilitation robotics faces the challenges of aligning engineering design with patient-specific needs. Most existing controllers in rehabilitation robots often constrain motion to fixed paths or provide only passive guidance, limiting user engagement and adaptability. This study proposes a novel active-assistive mode controller that integrates a virtual tunnel-based force generation mechanism with a dynamic moving-window technique for tracking activities of daily living (ADL) trajectories. Unlike conventional impedance controllers, the proposed method dynamically adjusts the virtual tunnel in real time, permitting voluntary upper-limb movement within a safe operational range while preventing excessive deviation. The system was implemented on a wearable two-degree-of-freedom (DOF) upper-limb exoskeleton equipped with drive and integrated sensor units. Experimental results demonstrated that decreasing the guidance force () increased tracking errors, from at 100% to at 30% , indicating greater voluntary participant motion. Peak actuator torques correspondingly decreased from 14.75 to 13.43 Nm (elbow) and from 4.14 to 2.48 Nm (wrist), confirming the controller’s capability to modulate robotic assistance according to user effort. Tests with 30 healthy participants demonstrated the effectiveness of guidance along predefined ADL trajectories, validating the controller’s potential for patient-centered rehabilitation. - 30 November 2025
- Published by Korean Institute of Information Technology in The Journal of Korean Institute of Information Technology
- Vol. 23 (11) , 101-108
Development of a ROS 2-based Digital Twin Environment for Mobile Robots
최근 디지털 트윈은 로봇 분야에서 실제와 가상 환경의 동기화를 통해 안전성과 효율성을 높이는 방안으로 주목받고 있다. 본 논문에서는 ROS 2를 기반으로 모바일 로봇과 가상 환경을 연동하여 디지털 트윈을 구현하였다. 제어 및 센서 데이터를 ROS 2 토픽으로 공유하도록 시스템을 구성하였으며, 실험에서는 직선 주행과 회전 동작을 비교하여 실제와 가상 로봇의 유사성을 검증하였다. 또한 각 로봇에 장착된 LiDAR 데이터를 동일한 메시지 구조로 발행하고 시각화하여, 센서 데이터가 네트워크상에서 호환 가능함을 확인하였다. 본 연구는 실제와 가상 로봇 간 양방향 제어 및 센서 연동이 가능한 디지털 트윈 구현 사례로, 향후 자율주행 및 복합 센서 융합 연구의 기반으로 활용될 수 있을 것으로 기대된다.
- 30 November 2025
- Published by Korean Institute of Information Technology in The Journal of Korean Institute of Information Technology
- Vol. 23 (11) , 101-108
Development of a ROS 2-based Digital Twin Environment for Mobile Robots
최근 디지털 트윈은 로봇 분야에서 실제와 가상 환경의 동기화를 통해 안전성과 효율성을 높이는 방안으로 주목받고 있다. 본 논문에서는 ROS 2를 기반으로 모바일 로봇과 가상 환경을 연동하여 디지털 트윈을 구현하였다. 제어 및 센서 데이터를 ROS 2 토픽으로 공유하도록 시스템을 구성하였으며, 실험에서는 직선 주행과 회전 동작을 비교하여 실제와 가상 로봇의 유사성을 검증하였다. 또한 각 로봇에 장착된 LiDAR 데이터를 동일한 메시지 구조로 발행하고 시각화하여, 센서 데이터가 네트워크상에서 호환 가능함을 확인하였다. 본 연구는 실제와 가상 로봇 간 양방향 제어 및 센서 연동이 가능한 디지털 트윈 구현 사례로, 향후 자율주행 및 복합 센서 융합 연구의 기반으로 활용될 수 있을 것으로 기대된다.