Rafael Andrew Choudhury
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Rafael Andrew Choudhury has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Chirag Gupta
Department of Electrical and Computer Engineering, University of Wisconsin-Madison , Madison, Wisconsin 53706
3 shared publications - Jiahao Chen
Department of Electrical and Computer Engineering, University of Wisconsin-Madison, Madison, WI, USA
3 shared publications - Ruixin Bai
Department of Electrical and Computer Engineering, University of Wisconsin-Madison, Madison, WI, USA
3 shared publications Ahmad E. Islam
Air Force Research Laboratory, Sensors Directorate, Wright-Patterson AFB, Dayton, OH, USA
2 shared publications- Andrew Joseph Green
Air Force Research Laboratory, Sensors Directorate 7 , WPAFB, Ohio 45433
2 shared publications Kyudong Kim
University of Wisconsin-Madison, Madison, WI, USA
2 shared publications
Latest Publications
- 12 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. PP (2771957X) , 1-4
Passivation-Free Ga-Polar AlGaN/GaN Recessed-Gate HEMTs on Sapphire With 2.8W/mm P OUT and 26.8% PAE at 94 GHz
In this work, we demonstrate a passivation-free Ga-polar recessed-gate AlGaN/GaN HEMT on a sapphire substrate for W-band operation, featuring a 5.5-nm Al0.35Ga0.65N barrier under the gate and a 31nm Al0.35Ga0.65N barrier in the gate access regions. The device achieves a drain current density of 1.7A/mm, a peak transconductance of 750mS/mm, and low gate leakage with a high on/off ratio of $10^{7}$ . Small-signal characterization reveals a current-gain cutoff frequency of 127GHz and a maximum oscillation frequency of 203GHz. Continuous-wave (CW) load-pull measurements at 94GHz demonstrate an output power density of 2.8W/mm with 26.8% power-added efficiency (PAE), both of which are approximately twice the values previously reported for Ga-polar GaN HEMTs fabricated on sapphire substrates and are comparable to state-of-the-art Ga-polar GaN HEMTs on SiC substrates. Considering the low cost of sapphire, the simplicity of the epitaxial design, and the reduced fabrication complexity relative to N-polar devices, this work highlights the potential of recessed-gate Ga-polar AlGaN/GaN HEMTs on sapphire as a promising candidate for next-generation millimeter-wave power applications.
- 12 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. PP (2771957X) , 1-4
Passivation-Free Ga-Polar AlGaN/GaN Recessed-Gate HEMTs on Sapphire With 2.8W/mm P OUT and 26.8% PAE at 94 GHz
In this work, we demonstrate a passivation-free Ga-polar recessed-gate AlGaN/GaN HEMT on a sapphire substrate for W-band operation, featuring a 5.5-nm Al0.35Ga0.65N barrier under the gate and a 31nm Al0.35Ga0.65N barrier in the gate access regions. The device achieves a drain current density of 1.7A/mm, a peak transconductance of 750mS/mm, and low gate leakage with a high on/off ratio of $10^{7}$ . Small-signal characterization reveals a current-gain cutoff frequency of 127GHz and a maximum oscillation frequency of 203GHz. Continuous-wave (CW) load-pull measurements at 94GHz demonstrate an output power density of 2.8W/mm with 26.8% power-added efficiency (PAE), both of which are approximately twice the values previously reported for Ga-polar GaN HEMTs fabricated on sapphire substrates and are comparable to state-of-the-art Ga-polar GaN HEMTs on SiC substrates. Considering the low cost of sapphire, the simplicity of the epitaxial design, and the reduced fabrication complexity relative to N-polar devices, this work highlights the potential of recessed-gate Ga-polar AlGaN/GaN HEMTs on sapphire as a promising candidate for next-generation millimeter-wave power applications.
- Open Access
- 8 January 2026
- Published by AIP Publishing in APL Electronic Devices
- Vol. 2 (1)
Temperature dependent high frequency performance of a 62% AlGaN channel HEMT
This article reports on the temperature dependent performance of a HEMT with an Al0.62Ga0.38N channel layer and an Al0.84Ga0.16N barrier layer grown by metal–organic chemical vapor deposition. The device in this report was measured at room temperature and elevated temperatures of 100–150 °C. The sheet resistance increased from 3.5 kΩ/sq (25 °C) to 5.4 kΩ/sq (150 °C), while the contact resistance remained nominally similar. For a device with 160 nm gate length and 2 μm source-to-drain length, excellent electrical characteristics have been achieved when the device was operated at 150 °C with a fT of 17 GHz and a fmax of 25.6 GHz. The reported device also exhibited outstanding gate leakage control, where 60% Al composition AlGaN channel HEMT, which suggests the great potential of AlGaN channel devices for high frequency, high power, high temperature applications.
- 8 January 2026
- Published by AIP Publishing in APL Electronic Devices
- Vol. 2 (1)
Open AccessTemperature dependent high frequency performance of a 62% AlGaN channel HEMT
This article reports on the temperature dependent performance of a HEMT with an Al0.62Ga0.38N channel layer and an Al0.84Ga0.16N barrier layer grown by metal–organic chemical vapor deposition. The device in this report was measured at room temperature and elevated temperatures of 100–150 °C. The sheet resistance increased from 3.5 kΩ/sq (25 °C) to 5.4 kΩ/sq (150 °C), while the contact resistance remained nominally similar. For a device with 160 nm gate length and 2 μm source-to-drain length, excellent electrical characteristics have been achieved when the device was operated at 150 °C with a fT of 17 GHz and a fmax of 25.6 GHz. The reported device also exhibited outstanding gate leakage control, where 60% Al composition AlGaN channel HEMT, which suggests the great potential of AlGaN channel devices for high frequency, high power, high temperature applications.