Nicolas Bayona Carrillo
Nicolas Bayona Carrillo has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Baptiste Flipon
Mines Paris, PSL University, Centre for Material Forming (CEMEF), UMR CNRS, 06904 Sophia Antipolis, France
2 shared publications - Lahcen Abaray2 shared publications
Malik Durand
1 shared publication- Malik Durand1 shared publication
Marc Bernacki
1 shared publication- Marc Bernacki
PSL University Centre for material forming (CEMEF) Mines Paris UMR CNRS 06904 Sophia Antipolis France
1 shared publication
Latest Publications
- Open Access
- 14 August 2026
- Published by Elsevier in SSRN Electronic Journal
Continuous Dynamic Recrystallization in Hot-Deformed AA2139 Aluminium Alloy: Influence of Thermomechanical Conditions and Crystallographic Orientation
Despite the well-established terminology used to distinguish continuous, discontinuous,and geometric dynamic recrystallization (CDRX, DDRX, and GDRX), the occurrenceand identification of DRX mechanisms in high-stacking-fault-energy materials, includingaluminium alloys, is still debated. This ambiguity limits the development of physicallybased models, especially regarding the origin of fine equiaxed grains fully enclosed byhigh-angle grain boundaries (HAGBs). In this work, the DRX behaviour of AA2139 aluminiumalloy was investigated during hot compression under various thermomechanicalconditions. Electron Backscatter Diffraction (EBSD) analyses were used to quantify lowanglegrain boundaries (LAGBs), HAGBs, geometrically necessary dislocations (GNDs),recrystallized grains, and texture. The results indicate that CDRX is the main activemechanism under the investigated conditions. This is supported by the progressive increasein LAGB disorientation, the higher fraction of 10-15° LAGBs, and the increase inHAGBs within the 15-35° range, which are consistent with the gradual transformation ofLAGBs into HAGBs. In contrast, GDRX remains limited, since 99.5% of the deformedmicrostructure remains too thick to satisfy the geometrical pinch-off condition. The kineticsof CDRX also vary with thermomechanical conditions: increasing strain and strainrate promote LAGB-to-HAGB transformation, while increasing temperature favours recrystallization through enhanced dislocation and grain boundary mobility. Finally, CDRXis orientation-dependent, with Near Cube grains developing denser LAGB networks andcontributing preferentially to the recrystallized grain population. These results providequantitative evidence for CDRX and highlight the need to include local crystallographicorientation in physically based models for hot deformation of aluminium alloys.
- 14 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessContinuous Dynamic Recrystallization in Hot-Deformed AA2139 Aluminium Alloy: Influence of Thermomechanical Conditions and Crystallographic Orientation
Despite the well-established terminology used to distinguish continuous, discontinuous,and geometric dynamic recrystallization (CDRX, DDRX, and GDRX), the occurrenceand identification of DRX mechanisms in high-stacking-fault-energy materials, includingaluminium alloys, is still debated. This ambiguity limits the development of physicallybased models, especially regarding the origin of fine equiaxed grains fully enclosed byhigh-angle grain boundaries (HAGBs). In this work, the DRX behaviour of AA2139 aluminiumalloy was investigated during hot compression under various thermomechanicalconditions. Electron Backscatter Diffraction (EBSD) analyses were used to quantify lowanglegrain boundaries (LAGBs), HAGBs, geometrically necessary dislocations (GNDs),recrystallized grains, and texture. The results indicate that CDRX is the main activemechanism under the investigated conditions. This is supported by the progressive increasein LAGB disorientation, the higher fraction of 10-15° LAGBs, and the increase inHAGBs within the 15-35° range, which are consistent with the gradual transformation ofLAGBs into HAGBs. In contrast, GDRX remains limited, since 99.5% of the deformedmicrostructure remains too thick to satisfy the geometrical pinch-off condition. The kineticsof CDRX also vary with thermomechanical conditions: increasing strain and strainrate promote LAGB-to-HAGB transformation, while increasing temperature favours recrystallization through enhanced dislocation and grain boundary mobility. Finally, CDRXis orientation-dependent, with Near Cube grains developing denser LAGB networks andcontributing preferentially to the recrystallized grain population. These results providequantitative evidence for CDRX and highlight the need to include local crystallographicorientation in physically based models for hot deformation of aluminium alloys.
- Top Cited PapersOpen Access
- 16 January 2026
- Published by Elsevier in Acta Materialia
- Vol. 306
Characterization and modeling of continuous dynamic recrystallization (CDRX): Application to 2139 aluminum alloy
- 16 January 2026
- Published by Elsevier in Acta Materialia
- Vol. 306
Top Cited PapersOpen AccessCharacterization and modeling of continuous dynamic recrystallization (CDRX): Application to 2139 aluminum alloy