Filippo Svelto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Filippo Svelto has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Ali Ameri
Department of Electrical Engineering and Computer Science (EECS), University of California, Berkeley, Berkeley, CA, USA
1 shared publication - Ali M. Niknejad
Department of Electrical Engineering and Computer Science (EECS), University of California, Berkeley, Berkeley, CA, USA
1 shared publication
Latest Publications
- 3 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (3) , 278-282
Frequency Stabilization of a 100-GHz VCO Using Resonator-Locked Loops in CMOS 28-nm
This brief presents a novel frequency-locking technique in which two off-tuned chopped active resonators define a reference frequency to which a 100GHz voltage-controlled oscillator (VCO) is locked. Deviations from the reference frequency result in a power imbalance between the resonator outputs. This imbalance is detected and used as an error signal to restore the VCO frequency to the reference point. The loop operates without frequency dividers and off-chip references. The implementation, fabricated in a CMOS 28nm process, achieves a close-in phase noise suppression of up to 5.6dB at -3dBm output power, consuming only 24mW.
- 3 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (3) , 278-282
Frequency Stabilization of a 100-GHz VCO Using Resonator-Locked Loops in CMOS 28-nm
This brief presents a novel frequency-locking technique in which two off-tuned chopped active resonators define a reference frequency to which a 100GHz voltage-controlled oscillator (VCO) is locked. Deviations from the reference frequency result in a power imbalance between the resonator outputs. This imbalance is detected and used as an error signal to restore the VCO frequency to the reference point. The loop operates without frequency dividers and off-chip references. The implementation, fabricated in a CMOS 28nm process, achieves a close-in phase noise suppression of up to 5.6dB at -3dBm output power, consuming only 24mW.