Ghulam Murtaza
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ghulam Murtaza has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Jane C. Batcheller
Department of Human Ecology, University of Alberta, Edmonton, AB T6G 2N1, Canada
2 shared publications E. M. Crown
Univ. of Alberta, Edmonton, Alberta, Canada
1 shared publication- Han Zhang
School of Mechatronic Engineering Southwest Petroleum University, Chengdu, China
1 shared publication J. D. Dale
Univ. of Alberta, Edmonton, Alberta, Canada
1 shared publication- José Antonio González
Applied Marine Ecology and Fisheries Division (EMAP), University Research Institute for Environmental Studies and Natural Resources (i‐UNAT), University of Las Palmas de Gran Canaria Las Palmas Spain
1 shared publication M. Y. Ackerman
Univ. of Alberta, Edmonton, Alberta, Canada
1 shared publication
Latest Publications
- 16 April 2015
- Published by SAGE Publications in Textile Research Journal
- Vol. 85 (20) , 2136-2146
Clothing in the kitchen: Evaluation of fabric performance for protection against hot surface contact, hot liquid and low-pressure steam burns
Kitchen workers sustain one of the highest rates of occupational burn injuries through exposure to the various thermal hazards present in institutional and restaurant kitchens. The jacket of the chefs’ uniform has the potential to act as a protective garment, although the extent of the protection afforded by this clothing has not been examined. This study evaluates a selection of current fabrics used in chefs’ uniform jackets to determine their effectiveness in providing protection against hot surface contact, hot liquids and low-pressure steam burns. Four jacket fabrics and two apron fabrics were tested as single layers and in layered combinations. Results showed that single-layered fabrics offered less protection against hot surface contact burns than double-layered fabrics, as an increase in fabric thickness improved thermal insulation of the system. Fabrics covered with a water-impermeable apron layer afforded the greatest protection against hot water and low-pressure steam, while fabrics covered with a permeable apron layer did not provide additional protection. It was found that the addition of the permeable apron fabric layer stored more thermal energy when exposed to hot water, potentially reducing the protection offered by the layered fabric systems.
- 16 April 2015
- Published by SAGE Publications in Textile Research Journal
- Vol. 85 (20) , 2136-2146
Clothing in the kitchen: Evaluation of fabric performance for protection against hot surface contact, hot liquid and low-pressure steam burns
Kitchen workers sustain one of the highest rates of occupational burn injuries through exposure to the various thermal hazards present in institutional and restaurant kitchens. The jacket of the chefs’ uniform has the potential to act as a protective garment, although the extent of the protection afforded by this clothing has not been examined. This study evaluates a selection of current fabrics used in chefs’ uniform jackets to determine their effectiveness in providing protection against hot surface contact, hot liquids and low-pressure steam burns. Four jacket fabrics and two apron fabrics were tested as single layers and in layered combinations. Results showed that single-layered fabrics offered less protection against hot surface contact burns than double-layered fabrics, as an increase in fabric thickness improved thermal insulation of the system. Fabrics covered with a water-impermeable apron layer afforded the greatest protection against hot water and low-pressure steam, while fabrics covered with a permeable apron layer did not provide additional protection. It was found that the addition of the permeable apron fabric layer stored more thermal energy when exposed to hot water, potentially reducing the protection offered by the layered fabric systems.
- 1 September 2012
- Published by ASTM International
- p. 1-21
Development of a Test Apparatus/Method and Material Specifications for Protection from Steam under Pressure
- 1 September 2012
- Published by ASTM International
- p. 1-21
Development of a Test Apparatus/Method and Material Specifications for Protection from Steam under Pressure