Liwen Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Liwen Hu has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
- Min Jiang
Southwestern Institute of Physics
4 shared publications - Peiwan Shi
Southwestern Institute of Physics
4 shared publications - Wei Chen
South-Western Institute of Physics
4 shared publications - Tengfei Sun
Southwestern Institute of Physics
3 shared publications - Sen Xu
Southwestern Institute of Physics, PO Box 432, Chengdu 610041, People’s Republic of China
2 shared publications - Ting Long
Southwestern Institute of Physics
2 shared publications
Latest Publications
- Open Access
- 28 August 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (10) , 106013
Investigation on fast ion losses induced by neoclassical tearing mode in HL-3 high- β plasmas
The fast ion losses (FIL) induced by m = 2 , n = 1 neoclassical tearing mode (NTM) are investigated dedicatedly in HL-3 high- β N plasmas, where m ( n ) is the poloidal (toroidal) mode number. The spectrogram of FIL fluctuation measured by FIL detector (FILD) shows a dominant characteristic frequency of the NTM rotation frequency, indicating that the NTM rotation modulates the fast ion (FI) loss. The lost FI population peaks at pitch-angle of 112 ∘ − 118 ∘ and energy ranges of 40 − 60 keV , consistent with the full energy of neutral beam. The intensity of the FILD signal is proportional to the square of island width, implying dominantly convective FIL. In addition, the NTM island structure passes through the lost orbit of the trapped FI, which is calculated backward in time from the FILD measurement, suggesting there exists an interaction between FI orbit and the NTM island. The calculation using ORBIT code reveals the wave-particle resonant condition is fulfilled between the NTM and the trapped FIs, further confirming the convective loss mechanism. The interaction primarily affects the toroidal canonical momentum rather than the energy of FIs due to the relatively low NTM frequency. These results enhance our understanding of NTM induced FI transport in high- β plasmas, providing valuable insight for optimizing the high-performance operation scenario for future fusion reactors.
- 28 August 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (10) , 106013
Open AccessInvestigation on fast ion losses induced by neoclassical tearing mode in HL-3 high- β plasmas
The fast ion losses (FIL) induced by m = 2 , n = 1 neoclassical tearing mode (NTM) are investigated dedicatedly in HL-3 high- β N plasmas, where m ( n ) is the poloidal (toroidal) mode number. The spectrogram of FIL fluctuation measured by FIL detector (FILD) shows a dominant characteristic frequency of the NTM rotation frequency, indicating that the NTM rotation modulates the fast ion (FI) loss. The lost FI population peaks at pitch-angle of 112 ∘ − 118 ∘ and energy ranges of 40 − 60 keV , consistent with the full energy of neutral beam. The intensity of the FILD signal is proportional to the square of island width, implying dominantly convective FIL. In addition, the NTM island structure passes through the lost orbit of the trapped FI, which is calculated backward in time from the FILD measurement, suggesting there exists an interaction between FI orbit and the NTM island. The calculation using ORBIT code reveals the wave-particle resonant condition is fulfilled between the NTM and the trapped FIs, further confirming the convective loss mechanism. The interaction primarily affects the toroidal canonical momentum rather than the energy of FIs due to the relatively low NTM frequency. These results enhance our understanding of NTM induced FI transport in high- β plasmas, providing valuable insight for optimizing the high-performance operation scenario for future fusion reactors.
- Open Access
- 1 August 2026
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (8) , 085008
Density limit experiments and core-localized kinetic ballooning modes in HL–2A Ohmic heating plasmas
The density limit is a mysterious barrier to magnetic confinement nuclear fusion, and is still an unresolved issue. In this paper, we will present the experimental results of the density limit and core-localized kinetic magnetohydrodynamics (MHD) instabilities on HL–2A. Firstly, the high density shots with n e / n e G > 1 have been achieved by the conventional gas-puff fueling method in Ohmic heating plasmas, and the corresponding duration time is close to t ∼ 500 ms ( ∼ 30 τ E ), where τ E is the global energy confinement time. Secondly, it is found for the first time that there are kinetic MHD instabilities in the core plasmas while n e / n e G ∼ 1 . The analysis suggests that the core-localized MHD activities belong to kinetic ballooning modes, and firstly it is found on experiment that they trigger the minor or major disruption of bulk plasmas while the density profile is peaked. These new findings are of great importance to figure out and understand the origin of the density limit.
- 1 August 2026
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (8) , 085008
Open AccessDensity limit experiments and core-localized kinetic ballooning modes in HL–2A Ohmic heating plasmas
The density limit is a mysterious barrier to magnetic confinement nuclear fusion, and is still an unresolved issue. In this paper, we will present the experimental results of the density limit and core-localized kinetic magnetohydrodynamics (MHD) instabilities on HL–2A. Firstly, the high density shots with n e / n e G > 1 have been achieved by the conventional gas-puff fueling method in Ohmic heating plasmas, and the corresponding duration time is close to t ∼ 500 ms ( ∼ 30 τ E ), where τ E is the global energy confinement time. Secondly, it is found for the first time that there are kinetic MHD instabilities in the core plasmas while n e / n e G ∼ 1 . The analysis suggests that the core-localized MHD activities belong to kinetic ballooning modes, and firstly it is found on experiment that they trigger the minor or major disruption of bulk plasmas while the density profile is peaked. These new findings are of great importance to figure out and understand the origin of the density limit.
- 27 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 54 (6) , 3023-3028
Multichannel Reflectometer for Core-Localized Electron Density Fluctuation Measurement on the HL-3 Tokamak
A novel multichannel microwave reflectometer has been developed for core-localized density fluctuation measurement on the HL-3 tokamak. The microwave diagnostic is characterized by having 16 independent microwave sources, achieving beam separation or combination through a multiplexer technique, and optimizing signal quality via remote control of amplifiers. Sixteen working points are arranged in a wide frequency region of 50–75 GHz, so that the microwave diagnostic has a large measurement range. Depending on detail requirement of tokamak operation, the reflectometer can work with ordinary or extraordinary waves. It is sensitive to density fluctuation and the corresponding maximum measurable wavenumber reaches $2.16~\rm cm^{-1}$ . Recently, the microwave reflectometer has been installed on HL-3 tokamak and utilized to measure the spatial location of pressure gradient-driven kinetic ballooning modes.
- 27 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 54 (6) , 3023-3028
Multichannel Reflectometer for Core-Localized Electron Density Fluctuation Measurement on the HL-3 Tokamak
A novel multichannel microwave reflectometer has been developed for core-localized density fluctuation measurement on the HL-3 tokamak. The microwave diagnostic is characterized by having 16 independent microwave sources, achieving beam separation or combination through a multiplexer technique, and optimizing signal quality via remote control of amplifiers. Sixteen working points are arranged in a wide frequency region of 50–75 GHz, so that the microwave diagnostic has a large measurement range. Depending on detail requirement of tokamak operation, the reflectometer can work with ordinary or extraordinary waves. It is sensitive to density fluctuation and the corresponding maximum measurable wavenumber reaches $2.16~\rm cm^{-1}$ . Recently, the microwave reflectometer has been installed on HL-3 tokamak and utilized to measure the spatial location of pressure gradient-driven kinetic ballooning modes.
- Open Access
- 23 April 2026
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (5) , 055005
Identification of mode numbers and wave numbers by multiple harmonics of instabilities
Harmonic phenomena of plasma instabilities are frequently observed in tokamak plasmas. The harmonics of instabilities have higher toroidal mode numbers than their base modes, leading to proportionally larger Doppler shifts. This paper presents a method for determining the toroidal mode number based on the frequency differences between harmonics. Based on Doppler shift effect, the toroidal mode number can be expressed as n = (f l -f 1 )/((l-1)f vϕ ), where l is the harmonic order and f vϕ is the toroidal rotation frequency. Compared to conventional techniques for mode number identification, the proposed approach offers advantages such as simplified data processing and lower requirement for the number of diagnostic channels. The harmonic components in the frequency spectrum can also be used to retrieve the instability frequency in the plasma frame. In this paper, it is demonstrated that the harmonics of plasma instabilities are not generated by intrinsic mode coupling, but are attributed to the nonlinear distortion of waveform. Diagnostic measurements, including soft X-ray and microwave interferometry, confirm that higher-order harmonics of plasma instabilities exist as real structural features inside the plasma and can interact with microwaves when the Bragg condition is satisfied. This property can be utilized to determine the perpendicular wave numbers of the instabilities. A simple physical model of the distribution of an instability and its harmonics is also proposed.
- 23 April 2026
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (5) , 055005
Open AccessIdentification of mode numbers and wave numbers by multiple harmonics of instabilities
Harmonic phenomena of plasma instabilities are frequently observed in tokamak plasmas. The harmonics of instabilities have higher toroidal mode numbers than their base modes, leading to proportionally larger Doppler shifts. This paper presents a method for determining the toroidal mode number based on the frequency differences between harmonics. Based on Doppler shift effect, the toroidal mode number can be expressed as n = (f l -f 1 )/((l-1)f vϕ ), where l is the harmonic order and f vϕ is the toroidal rotation frequency. Compared to conventional techniques for mode number identification, the proposed approach offers advantages such as simplified data processing and lower requirement for the number of diagnostic channels. The harmonic components in the frequency spectrum can also be used to retrieve the instability frequency in the plasma frame. In this paper, it is demonstrated that the harmonics of plasma instabilities are not generated by intrinsic mode coupling, but are attributed to the nonlinear distortion of waveform. Diagnostic measurements, including soft X-ray and microwave interferometry, confirm that higher-order harmonics of plasma instabilities exist as real structural features inside the plasma and can interact with microwaves when the Bragg condition is satisfied. This property can be utilized to determine the perpendicular wave numbers of the instabilities. A simple physical model of the distribution of an instability and its harmonics is also proposed.