JLJ A Labbate

J A Labbate

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


J A Labbate has a total of 80 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Pedestal penalty factors for ELM-free regimes in DIII-D and extension to fusion pilot plant design

    by A O Nelson, T Odstrčil, T Slendebroek, Z Li, N Leuthold, C F B Zimmermann, J Labbate, J Dunsmore, J Schellpfeffer, S Denk, et al.

    Though the EPED model, which provides a first-principles-based predictive capability for the pedestal height and width in H-mode tokamak plasmas, has been validated extensively in type-I edge-localized mode (ELM) regimes, significant uncertainties remain in predicting the height of the pressure pedestal in fusion pilot plants that must deploy ELM mitigation or suppression techniques. In this work, we compare the EPED1 NN surrogate to measurements from a broad dataset on the DIII-D tokamak, spanning ELMy, Small-ELM, QH-mode, Wide-Pedestal QH-mode, resonant magnetic perturbation-suppressed, I-mode, EDA H-mode, QCE and ELM-free NT scenarios. Using a robust Bayesian profile-fitting framework, we find that the measured pedestal pressure is systematically reduced relative to the EPED prediction in nearly all regimes, with regime-median pedestal pressures ranging from ∼ 93% of the predicted value in H-mode like regimes to below 40% in scenarios in which the edge region is governed by other transport mechanisms. We show that this deficit—termed a ‘pedestal penalty’ – is not a fixed per-regime offset and that some scenarios recover toward the EPED prediction at high normalized pressure ( β N ) and low pedestal collisionality ( ν e , ped ∗ ). While a simple scaling for the pedestal penalty can help illustrate model uncertainties on the DIII-D database, it misses key scenario-specific physics and should not be taken as a substitute for the development of predictive pedestal models for ELM-free FPPs. Uncertainties in FPP performance associated with a reduction of the pedestal height relative to EPED are quantified using the FUSE code, which shows that the achievable fusion power on ITER may be reduced by a factor of two if the pedestal is limited to 60% of the EPED prediction, a value well within the uncertainties observed on DIII-D. Further implications for FPP design are discussed, including the need for regime-dependent pedestal models that do not rely on a degraded EPED variant.

  • Open Access

    Compact experimental negative triangularity reactor (CENTAUR): a design study for a compact, affordable breakeven tokamak

    by S Freiberger, E M Bursch, J Chiriboga, H J Farre-Kaga, E Felske, S Guizzo, J A Labbate, S Seethalla, F Sheehan, J L Xia, et al.

    This work presents the compact experimental negative triangularity (NT) reactor (CENTAUR), a low overnight cost, high-field tokamak, breakeven reactor design, achieving a predicted total fusion power of 40 MW and scientific energy gain of 1.3. Ballooning stability calculations confirm that the device’s pedestal is within the first stability regime, which is consistent with the expected ELM-free operation associated with NT plasmas. The geometry of the NT divertor allows for high fraction of radiated power (13.5 % ) between the separatrix and plasma facing components. Heat transport modeling based on simulations of the edge region show heat loads into plasma facing components well below material limits. The magnet system employs rare-earth barium copper oxide high-temperature superconductors in 18 toroidal field coils, an hourglass-shaped central solenoid, and six poloidal field coils to support high-field ( B 0 = 10.9 T) plasma confinement, shaping, and current drive. Neutronics analysis shows that a 12 cm B 4 C shield keeps superconducting magnet heating below the 33 K quench limit during 10 s, 40 MW DT pulses. With this shielding, the modeled fluence indicates HTS components can survive more than ten times the 3000-pulse design lifetime. Iteration of economic analysis in tandem with the technical design process allows CENTAUR to achieve its overnight cost goal of $2 billion US determined using a custom costing model that predicts a total overnight cost of 1.6 B ± 0.2 B US.


  • Top Cited Papers
    Open Access

    Overview of the helios design: A practical planar coil stellarator fusion power plant

    by C.P.S. Swanson, S.T.A. Kumar, D.W. Dudt, E.R. Flom, W.B. Kalb, T.G. Kruger, M.F. Martin, J.R. Olatunji, S. Pasmann, L.Z. Tang, et al.


  • Top Cited Papers
    Open Access

    Alpha confinement in the quasi-axisymmetric Helios fusion power plant

    by J. von der Linden, J.A. Labbate, E.J. Paul, E.R. Flom, D.W. Dudt, R.H. Wu, T.G. Kruger, C.P.S. Swanson, S.T.A. Kumar, D.A. Gates