BTBaurzhan Temov

Baurzhan Temov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Baurzhan Temov has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Development of a statistical model for walnut shelling in a reciprocating millstone unit

    by Baurzhan Temov, Baurzhan Nurakhmetov, Ardak Askarov, Ilyas Nurakhmetov, Galymzhan Nasrullin

    The object of this study is the process of walnut shelling in a reciprocating millstone, implementing combined compression, shear, and torsion loading. The problem being addressed is the lack of well-founded modes that simultaneously ensure complete shell destruction and a high yield of whole kernels—two conflicting requirements in processing. This study extends previous work that determined the shell fracture forces and the probabilistic nature of its failure; this work transitions from the strength characteristics of the object to machine performance. A three-factor rotatable design of a central composite experiment (Box design) consisting of twenty trials was implemented. The factors included the angular velocity of the moving upper millstone (1.38–4.90 rad/s), the number of nut revolutions in the working channel (0.33–1.17 revolutions), and the roughness pitch of the working surfaces (7.95–18.05 mm). Two responses were recorded: shell fracture rate and whole kernel yield. Second-order regression models were obtained and tested using analysis of variance. It was found that shell fracture rate increases with increasing angular velocity and rotational speed and decreases with increasing roughness pitch, while whole kernel yield decreases with increasing angular velocity and exhibits internal maxima at rotational speed and roughness pitch. Angular velocity is the dominant factor for both responses and serves as the main source of the tradeoff between cracking and kernel integrity. A compromise regime was identified: angular velocity of approximately 2.09 rad/s, approximately 1.0 nut revolution, and a roughness pitch of approximately 10 mm, resulting in a shell fracture rate of approximately 94.5% with a whole kernel yield of approximately 88.9%. The results serve as a basis for selecting walnut shelling machine parameters

  • Open Access

    Identifying patterns of walnut shell fracture under combined loading in a reciprocating millstone system

    by Baurzhan Temov, Baurzhan Nurakhmetov, Ardak Askarov, Ilyas Nurakhmetov, Galymzhan Nasrullin

    This study explores the process of shell fracture in a locally cultivated walnut variety in a reciprocating millstone setup that implements combined compression, shear, and torsion loading. The task addressed is to enable cracking across the entire shell surface while maintaining kernel integrity, which determines the yield of marketable produce. In the first stage, shell fracture forces were experimentally determined under localized loading from a natural cleft and a whole shell, followed by statistical processing using a two-parameter Weibull distribution. It was found that fracture from the cleft side occurs at lower loads than from the whole shell side, confirming the anisotropy of the shell's mechanical properties. In the second stage, the effect of roughness pitches of 10, 13, and 16 mm on the fracture force was studied. Experiments have shown that at a 10 mm pitch, fracture occurs with the lowest force; increasing the pitch to 13 and 16 mm increases the fracture force due to a decrease in local stress concentration. A comparison of the two experimental stages revealed that the geometry of the working surfaces determines the conditions for fracture without changing the general pattern: when loading from a natural cleft, lower forces are required. For a fracture probability of at least 0.95 for any nut orientation, a load of approximately 350 N is required. Additionally, the strength characteristics of the kernel were determined using an ST-2 structure analyzer; the average fracture force under direct loading is approximately 1200 grams (≈ 120 N). The results provide a mechanically sound basis for selecting the parameters of the working parts of a nut cracking machine and a safe range of operating loads