Toru Kinoshita
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Toru Kinoshita has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
Jeffrey Britt
HexaTech, Inc. , 991 Aviation Parkway Suite 800, Morrisville, North Carolina 27560
1 shared publication- Rafael Dalmau
HexaTech, Inc
1 shared publication - Samuel Kirby
HexaTech, Inc. , 991 Aviation Parkway Suite 800, Morrisville, North Carolina 27560
1 shared publication
Latest Publications
- Open Access
- 1 June 2026
- Published by AIP Publishing in AIP Advances
- Vol. 16 (6)
High temperature N2 annealing for N-polar bulk AlN substrates
High temperature annealing treatments with two different wafer configurations under N2 atmosphere were performed to improve the N-polar surface quality of bulk AlN substrates and to mitigate its impact on the morphology and structural properties of subsequently grown homoepitaxial films. After N2 annealing at 1700–1850 °C, scratches and particles that remained on the as-CMP N-polar surface completely disappeared. The annealed N-polar surface consisted of a step-and-terrace structure with step heights of ∼0.5 nm and uniform terrace widths. For single wafer configuration anneals, the etching rate increased from 0.32 μm/h to 2.54 μm/h with annealing temperature, while the step retreat velocity estimated from etching increased from 18.4 to 155.6 nm/s over the same temperature range. An activation energy for etching of 5.0 eV for the single wafer annealing configuration was calculated. Although surface pits were observed after N2 annealing in the single wafer configuration, the use of a proximity cap configuration reduced the pit density to less than 0.3 mm−2 and produced smooth surfaces. Furthermore, AlN films grown by MOCVD on annealed substrates exhibited a significant reduction in the density of surface hillocks as compared to those grown on unannealed substrates. This study provides a general AlN pre-epi wafer annealing approach to improve the morphology and surface quality of N-polar AlN substrates and subsequently grown homoepitaxial films.
- 1 June 2026
- Published by AIP Publishing in AIP Advances
- Vol. 16 (6)
Open AccessHigh temperature N2 annealing for N-polar bulk AlN substrates
High temperature annealing treatments with two different wafer configurations under N2 atmosphere were performed to improve the N-polar surface quality of bulk AlN substrates and to mitigate its impact on the morphology and structural properties of subsequently grown homoepitaxial films. After N2 annealing at 1700–1850 °C, scratches and particles that remained on the as-CMP N-polar surface completely disappeared. The annealed N-polar surface consisted of a step-and-terrace structure with step heights of ∼0.5 nm and uniform terrace widths. For single wafer configuration anneals, the etching rate increased from 0.32 μm/h to 2.54 μm/h with annealing temperature, while the step retreat velocity estimated from etching increased from 18.4 to 155.6 nm/s over the same temperature range. An activation energy for etching of 5.0 eV for the single wafer annealing configuration was calculated. Although surface pits were observed after N2 annealing in the single wafer configuration, the use of a proximity cap configuration reduced the pit density to less than 0.3 mm−2 and produced smooth surfaces. Furthermore, AlN films grown by MOCVD on annealed substrates exhibited a significant reduction in the density of surface hillocks as compared to those grown on unannealed substrates. This study provides a general AlN pre-epi wafer annealing approach to improve the morphology and surface quality of N-polar AlN substrates and subsequently grown homoepitaxial films.