Peng Zhou
Research Subjects
Peng Zhou has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Bing Zhang
Xinjiang Shenergy Petroleum Co., Ltd., Shanghai 200041, China
1 shared publication - Chengxin Liu
Xinjiang Shenergy Petroleum Co., Ltd., Shanghai 200041, China
1 shared publication - Fang Ding
China National Offshore Oil Corporation (China) Co., Ltd., Shanghai Branch, Shanghai 200335, China
1 shared publication - Fengguang Xu
Xinjiang Shenergy Petroleum Co., Ltd., Shanghai 200041, China
1 shared publication - Gangxiang Song
China National Offshore Oil Corporation (China) Co., Ltd., Shanghai Branch, Shanghai 200335, China
1 shared publication - Hao Zhang
Xinjiang Shenergy Petroleum Co., Ltd., Shanghai 200041, China
1 shared publication
Latest Publications
- Open Access
- 1 August 2026
- Published by MDPI AG in Geosciences
- Vol. 16 (8) , 308
Characteristics and Exploration Potential Evaluation of Lower Cambrian Source Rocks in the Southern Keping Area, Tarim Basin
Despite recent Cambrian subsalt gas discoveries in the Keping fault-uplift, northwestern Tarim Basin, organic abundance, type, maturity, and depositional setting of Lower Cambrian source rocks remain poorly documented. We evaluated the Yuertusi and Lower Xiaoerbulake Formations using total organic carbon (TOC) analysis, Rock-Eval pyrolysis, kerogen microscopy, solid bitumen reflectance, X-ray diffraction, and ICP-MS trace-element analysis of samples from 11 wells and 6 outcrops. The Yuertusi Formation is organic-rich in northern Keping (TOC = 0.13–28.20%) but thins and deteriorates southward. The Lower Xiaoerbulake Formation (TOC = 0.10–9.68%; 70–160 m thick) is a widespread, moderate-to-good source rock, challenging the view that the Yuertusi Formation is the only Cambrian source rock. Sapropelinite-dominated kerogen (>80%) indicates Type I–II organic matter; equivalent vitrinite reflectance (2.28–3.50%) confirms overmature, gas-prone rocks. The Yuertusi Formation reflects upwelling-fed high productivity and anoxic–euxinic waters; the Lower Xiaoerbulake Formation, moderately high productivity and dysoxic waters. The subsalt gas is oil-cracked gas from marine sapropelic source rocks of either formation. Chloroform bitumen “A” estimates give in-place gas resources of 1121.4 × 109 m3; the static share for southern Keping (20.1 × 109 m3) understates its dynamic potential. A lower-generation/upper-reservoir, fault-controlled, near-source model favors Trap 1-1 for future drilling.
- 1 August 2026
- Published by MDPI AG in Geosciences
- Vol. 16 (8) , 308
Open AccessCharacteristics and Exploration Potential Evaluation of Lower Cambrian Source Rocks in the Southern Keping Area, Tarim Basin
Despite recent Cambrian subsalt gas discoveries in the Keping fault-uplift, northwestern Tarim Basin, organic abundance, type, maturity, and depositional setting of Lower Cambrian source rocks remain poorly documented. We evaluated the Yuertusi and Lower Xiaoerbulake Formations using total organic carbon (TOC) analysis, Rock-Eval pyrolysis, kerogen microscopy, solid bitumen reflectance, X-ray diffraction, and ICP-MS trace-element analysis of samples from 11 wells and 6 outcrops. The Yuertusi Formation is organic-rich in northern Keping (TOC = 0.13–28.20%) but thins and deteriorates southward. The Lower Xiaoerbulake Formation (TOC = 0.10–9.68%; 70–160 m thick) is a widespread, moderate-to-good source rock, challenging the view that the Yuertusi Formation is the only Cambrian source rock. Sapropelinite-dominated kerogen (>80%) indicates Type I–II organic matter; equivalent vitrinite reflectance (2.28–3.50%) confirms overmature, gas-prone rocks. The Yuertusi Formation reflects upwelling-fed high productivity and anoxic–euxinic waters; the Lower Xiaoerbulake Formation, moderately high productivity and dysoxic waters. The subsalt gas is oil-cracked gas from marine sapropelic source rocks of either formation. Chloroform bitumen “A” estimates give in-place gas resources of 1121.4 × 109 m3; the static share for southern Keping (20.1 × 109 m3) understates its dynamic potential. A lower-generation/upper-reservoir, fault-controlled, near-source model favors Trap 1-1 for future drilling.
- Open Access
Case Study of Dynamic Stratified Production Allocation and Remaining Oil Evaluation in Offshore Multilayer Commingled Reservoirs with Strong Aquifers
After prolonged development, offshore edge- and bottom-water reservoirs have entered an ultra-high water-cut stage. Under long-time multilayer commingled production conditions, accurate dynamic quantification of layer-wise production remains technically challenging, and conventional production allocation approaches often lack the accuracy required for fine-scale reservoir management. To address these challenges, this study proposes a production allocation method that integrates static reservoir properties, dynamic production performance, and pressure-based correction. The resulting layer-wise allocation provides a quantitative basis for evaluating remaining oil utilization and delineating the distribution of remaining oil across individual layers. The method is formulated on the basis of a pseudo-steady-state productivity model that incorporates wellbore imperfection effects. The initial production rate of each layer is calculated by combining reservoir transmissibility with production pressure drawdown. To account for unequal pressure responses among layers under commingled production—resulting from pressure imbalance, limited edge- and bottom-water energy support, and interlayer interference—a correction factor is introduced to adjust the effective production contribution of low-pressure layers. Compared with the PLT test results, the average error of the conventional KH method was 16.7%, whereas the average error of the proposed method was reduced to 6.1%. The average error was reduced from 16.7% to 6.1%, corresponding to a 63.5% reduction in prediction error, indicating that the proposed approach can provide a more reliable estimation of layered production contribution. The proposed method enables continuous and dynamic production allocation for commingled wells without the need for frequent surveys, offering a practical tool for identifying multilayer production imbalance, evaluating remaining potential, and supporting development optimization in offshore oilfields.
Open AccessCase Study of Dynamic Stratified Production Allocation and Remaining Oil Evaluation in Offshore Multilayer Commingled Reservoirs with Strong Aquifers
After prolonged development, offshore edge- and bottom-water reservoirs have entered an ultra-high water-cut stage. Under long-time multilayer commingled production conditions, accurate dynamic quantification of layer-wise production remains technically challenging, and conventional production allocation approaches often lack the accuracy required for fine-scale reservoir management. To address these challenges, this study proposes a production allocation method that integrates static reservoir properties, dynamic production performance, and pressure-based correction. The resulting layer-wise allocation provides a quantitative basis for evaluating remaining oil utilization and delineating the distribution of remaining oil across individual layers. The method is formulated on the basis of a pseudo-steady-state productivity model that incorporates wellbore imperfection effects. The initial production rate of each layer is calculated by combining reservoir transmissibility with production pressure drawdown. To account for unequal pressure responses among layers under commingled production—resulting from pressure imbalance, limited edge- and bottom-water energy support, and interlayer interference—a correction factor is introduced to adjust the effective production contribution of low-pressure layers. Compared with the PLT test results, the average error of the conventional KH method was 16.7%, whereas the average error of the proposed method was reduced to 6.1%. The average error was reduced from 16.7% to 6.1%, corresponding to a 63.5% reduction in prediction error, indicating that the proposed approach can provide a more reliable estimation of layered production contribution. The proposed method enables continuous and dynamic production allocation for commingled wells without the need for frequent surveys, offering a practical tool for identifying multilayer production imbalance, evaluating remaining potential, and supporting development optimization in offshore oilfields.