Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xiaojia Zhang has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    AI-Enhanced Detection of Thermal Anomalies in Urban Roofs via Drone-Assisted Infrared Thermography (UAV-IRT)

    by Xiaojia Zhang, Andrea Garzulino, Elena Lucchi

    This study investigates automated detection of rooftop thermal anomalies using Unmanned Aerial Vehicle-Based Infrared Thermography (UAV-IRT) and deep learning object detection models. UAV thermal images are used to identify potential thermal bridges on building rooftops. The experiment is framed as a preliminary workflow validation performed on a subset of the Karlsruhe reference dataset. The study evaluates four YOLO models, including YOLOv9, YOLOv10, YOLOv11, and YOLOv12. The results indicate that all models can detect major thermal anomaly regions in UAV thermal imagery. YOLOv9 achieves slightly higher detection accuracy in the tested dataset. These results demonstrate the feasibility of the proposed workflow under reference-dataset conditions, while validation on a dedicated historic-building dataset remains necessary before claiming applicability to heritage or historic urban environments.


  • Open Access

    Drone-Based Quantitative Infrared Thermography (UAV-QIRT) for In Situ U-Value Estimation: A Critical Comparison of Numerical Models for Building Façades

    by Xiaojia Zhang, Elena Lucchi, Andrea Garzulino

    Buildings account for a substantial share of global energy consumption and greenhouse gas emissions, while a large proportion of the existing building stock remains energy inefficient. Thermal transmittance is a fundamental indicator for assessing the thermal performance of historic building envelopes. This study investigates the application of UAV-based quantitative infrared thermography (UAV-QIRT) for in situ U-value measurement as an alternative to conventional methods. This study proposes a structured workflow for UAV-QIRT-based U-value measurement, developed in accordance with BS EN ISO 6781-1:2023. The study evaluates four U-value calculation formulas using thermographic data acquired during an in situ case study and compares the resulting estimates with a reference U-value obtained using the heat flow meter (HFM) method. The results demonstrate that the reliability of UAV-QIRT-based U-value estimation strongly depends on outdoor thermal boundary conditions and the physical assumptions embedded within the heat balance model. In this case, the measured exterior wall surface temperature was lower than the outdoor air temperature, causing simplified formulas to produce physically unrealistic negative U-values. In contrast, the complete heat balance model, which accounts for radiative exchanges with the sky, surroundings, and ground, as well as convective heat transfer, generated more plausible estimates. Nevertheless, significant discrepancies were observed between the UAV-QIRT and HFM estimates. Sensitivity analysis revealed a high dependence of UAV-QIRT-derived U-values on environmental boundary conditions, including wind speed, outdoor air temperature, and exterior surface temperature.