Takashi Ohno
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Takashi Ohno has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Hiroki Watanabe
Department of Electrical, Electronics, and Information Engineering, Nagaoka University of Technology, Nagaoka, Japan
1 shared publication - Jun-Ichi Itoh
Department of Electrical, Electronics, and Information Engineering, Nagaoka University of Technology, Nagaoka, Japan
1 shared publication - Rintaro Kusui
Department of Science of Technology Innovation, Nagaoka University of Technology, Nagaoka, Japan
1 shared publication
Latest Publications
- 6 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (9) , 15577-15593
Three-Level Current-Fed Dual Active Bridge Converter for Wide Voltage Range Interconnected to a 1500-V DC Grid
This article proposes a highly efficient control method over a wide operating range in a flying capacitor-type current-fed dual active bridge converter. The circuit configuration on the low-voltage side integrates an interleaved boost converter and a single-phase inverter. The circuit configuration on the high-voltage side consists of a flying capacitor (FC) converter to accept a medium voltage of 1500 V DC grid. The output voltage of the FC converter is switched between the DC-grid voltage and half of the DC-grid voltage, depending on the input voltage and load conditions, to improve efficiency. A flying capacitor-type current-fed dual active bridge (FCCF-DAB) converter applies a triangular current mode (TCM) to achieve zero voltage switching (ZVS) for the low-voltage side. The operating condition of the DC-bus voltage has to be determined to achieve the minimum loss, which depends on the balance between the switching and conduction losses. Based on the loss analysis, the optimal operating point is identified and utilized in the experiment. The experimental results with the minimum loss DC-bus voltage demonstrate that conversion loss is reduced by 23.7% at an input voltage of 300 V and an output power of 7.8 kW. Furthermore, a design guideline for achieving ZVS under all voltage and load conditions is presented. The validity of the guideline is demonstrated through experiments using a prototype.
- 6 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (9) , 15577-15593
Three-Level Current-Fed Dual Active Bridge Converter for Wide Voltage Range Interconnected to a 1500-V DC Grid
This article proposes a highly efficient control method over a wide operating range in a flying capacitor-type current-fed dual active bridge converter. The circuit configuration on the low-voltage side integrates an interleaved boost converter and a single-phase inverter. The circuit configuration on the high-voltage side consists of a flying capacitor (FC) converter to accept a medium voltage of 1500 V DC grid. The output voltage of the FC converter is switched between the DC-grid voltage and half of the DC-grid voltage, depending on the input voltage and load conditions, to improve efficiency. A flying capacitor-type current-fed dual active bridge (FCCF-DAB) converter applies a triangular current mode (TCM) to achieve zero voltage switching (ZVS) for the low-voltage side. The operating condition of the DC-bus voltage has to be determined to achieve the minimum loss, which depends on the balance between the switching and conduction losses. Based on the loss analysis, the optimal operating point is identified and utilized in the experiment. The experimental results with the minimum loss DC-bus voltage demonstrate that conversion loss is reduced by 23.7% at an input voltage of 300 V and an output power of 7.8 kW. Furthermore, a design guideline for achieving ZVS under all voltage and load conditions is presented. The validity of the guideline is demonstrated through experiments using a prototype.