Yanxin Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yanxin Hu has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Bogu Huang
College of Information Science and Engineering, Northeastern University, Shenyang 110819, China
1 shared publication - Wentao Yang
School of Information Science and Engineering, Northeastern University, Shenyang 110819, China
1 shared publication - Yibo Wang
College of Information Science and Engineering, Northeastern University, Shenyang, China
1 shared publication - Yuhan Guo
School of Information Science and Engineering, Northeastern University, Shenyang 110819, China
1 shared publication - Yuxuan Wu
School of Information Science and Engineering, Northeastern University, Shenyang 110819, China
1 shared publication
Latest Publications
- Open Access
- 12 August 2026
- Published by MDPI AG in Mathematics
- Vol. 14 (16) , 2908
Impedance Reshaping Control for Stability Enhancement of Grid-Following Inverters in Weak Grids
Although the weak-grid stability of grid-following inverters has been widely studied, traditional SCR-based assessment mainly describes grid strength and does not directly quantify the minimum SCR required for stable operation under a specified active-power command. This paper uses a critical-SCR-oriented operating-boundary evaluation to compare the control-dependent dynamic stability requirement with the physical steady-state feasibility limit. It proposes a channel-specific impedance-reshaping extension that retains the PLL-related q-q and d-q compensation paths and adds a voltage-loop-related q-d compensation path. The added path reduces the control-induced dynamic critical SCR, thereby allowing stable operation at lower SCR than with the original control structure. Firstly, the steady-state critical SCR is derived from the steady-state power-transfer relation under a specified active-power command to define the physical feasibility lower bound, and the dynamic critical SCR is identified using a scanning procedure based on the generalized Nyquist criterion. The resulting control-induced SCR gap quantifies the additional grid-strength requirement introduced by the control dynamics. Secondly, a simplified d-q admittance representation is used to relate established PLL-related and voltage-loop-related coupling effects to the corresponding compensation paths. Thirdly, the proposed channel-specific impedance-reshaping design is used to mitigate these effects while retaining the selected voltage-loop bandwidth, and an anti-drift correction is further introduced to improve implementation robustness. Frequency-domain analysis and time-domain simulations validate the dynamic critical-SCR evaluation, while hardware-in-the-loop experiments demonstrate the real-time operation of the proposed controller. The results show that it moves the dynamic critical-SCR boundary close to the steady-state physical boundary and improves the weak-grid stability margin. The hardware-in-the-loop results further confirm bounded operation under SCR and frequency steps.
- 12 August 2026
- Published by MDPI AG in Mathematics
- Vol. 14 (16) , 2908
Open AccessImpedance Reshaping Control for Stability Enhancement of Grid-Following Inverters in Weak Grids
Although the weak-grid stability of grid-following inverters has been widely studied, traditional SCR-based assessment mainly describes grid strength and does not directly quantify the minimum SCR required for stable operation under a specified active-power command. This paper uses a critical-SCR-oriented operating-boundary evaluation to compare the control-dependent dynamic stability requirement with the physical steady-state feasibility limit. It proposes a channel-specific impedance-reshaping extension that retains the PLL-related q-q and d-q compensation paths and adds a voltage-loop-related q-d compensation path. The added path reduces the control-induced dynamic critical SCR, thereby allowing stable operation at lower SCR than with the original control structure. Firstly, the steady-state critical SCR is derived from the steady-state power-transfer relation under a specified active-power command to define the physical feasibility lower bound, and the dynamic critical SCR is identified using a scanning procedure based on the generalized Nyquist criterion. The resulting control-induced SCR gap quantifies the additional grid-strength requirement introduced by the control dynamics. Secondly, a simplified d-q admittance representation is used to relate established PLL-related and voltage-loop-related coupling effects to the corresponding compensation paths. Thirdly, the proposed channel-specific impedance-reshaping design is used to mitigate these effects while retaining the selected voltage-loop bandwidth, and an anti-drift correction is further introduced to improve implementation robustness. Frequency-domain analysis and time-domain simulations validate the dynamic critical-SCR evaluation, while hardware-in-the-loop experiments demonstrate the real-time operation of the proposed controller. The results show that it moves the dynamic critical-SCR boundary close to the steady-state physical boundary and improves the weak-grid stability margin. The hardware-in-the-loop results further confirm bounded operation under SCR and frequency steps.