WWWenxun Wei

Wenxun Wei

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Wenxun Wei has a total of 7 co-authors. Here are the top co-authors by number of shared publications:

  • Daiyin Zhu

    Key Laboratory of Radar Imaging and Microwave Photonics, Ministry of Education, School of Electronic Information Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 211106, China

    2 shared publications
  • Danfeng Qiu

    Key Laboratory of Radar Imaging and Microwave Photonics, Ministry of Education, School of Electronic Information Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 211106, China

    2 shared publications
  • Jinlong Ma

    Key Laboratory of Radar Imaging and Microwave Photonics, Ministry of Education, School of Electronic Information Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 211106, China

    2 shared publications
  • Xin Chen

    Key Laboratory of Radar Imaging and Microwave Photonics, Ministry of Education, School of Electronic Information Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 211106, China

    2 shared publications
  • Zongguang Yu

    The 58th Research Institute of China Electronic Technology Group Corporation (CETC), Wuxi 214072, China

    2 shared publications
  • Weike Liu

    Shanghai Institute of Satellite Engineering, Shanghai 201109, China

    1 shared publication

Latest Publications

    • 19 November 2026
    • Published by MDPI AG in Electronics
      • Vol. 15  (22) , 5390
      • https://doi.org/10.3390/electronics15225390
    Open Access

    Quantitative Trade-Off Evaluation of Hardened DFFs in 130 nm ProASIC3 Flash-Based FPGAs Under Wide-LET Heavy-Ion Irradiation

    by Jinlong Ma, Weike Liu, Wenxun Wei, Xin Chen, Danfeng Qiu, Zongguang Yu, Daiyin Zhu

    Single-event upset (SEU) hardening of native D flip-flops (DFFs) in flash-based field-programmable gate arrays (FPGAs) lacks unified experimental conditions and quantitative selection criteria; this work implements six DFF structures on one and the same A3PE3000 chip as identical dual 243-bit shift-register test chains. These include an unhardened baseline DFF (BL-DFF), a conventional triple-modular-redundancy DFF (TMR-DFF), three delay-filtering TMR-DFF variants (DF-TMR-DFF), and one dual-path combinational-logic-replica TMR-DFF (DCLR-TMR-DFF). Realized DF-TMR-DFF filtering windows are set by on-chip process–voltage–temperature (PVT) calibration rather than nominal design values. Six heavy-ion species are used, with linear energy transfer (LET) of 4.4–82.06 MeV·cm2/mg, and irradiation data are processed through a five-stage procedure to remove terminal output-stage single-event transients (SETs) and retain genuine bit-cell upsets. All cross-sections are normalized per logic bit (one complete instance) rather than per storage cell. At the highest LET, the DCLR-TMR-DFF achieves the lowest cross-section of 8.23 × 10−10 cm2/bit, approximately 1/145 and 1/27 of the BL-DFF and TMR-DFF cross-sections, respectively; the DF-TMR-DFF cross-sections decrease from 1.58 × 10−8 to 2.06 × 10−9 cm2/bit as the filtering windows widen. The proposed analytical model shows that which of the DF-TMR-DFF and the DCLR-TMR-DFF has the lower per-bit VersaTile overhead depends on the delay-stage count relative to the combinational-to-sequential resource ratio ρ0, with measured per-bit overheads from 11 (BL-DFF) to 37 (DCLR-TMR-DFF) VersaTiles. Post-layout static timing analysis (STA) of standalone projects gives maximum frequencies of 59.034, 52.384, and 43.092 MHz for BL-DFF, TMR-DFF, and DCLR-TMR-DFF, and 40.827–32.083 MHz for the DF-TMR-DFF variants, whose radiation-hardness gain comes at the expense of timing performance. No structure is optimal across all three dimensions, and trade-offs are required in design. A four-tier engineering selection boundary is established for 130 nm ProASIC3 space circuits. All TMR-based structures share an inherent single-point vulnerability at the terminal three-input majority voter.

  • Open Access

    On-Chip Measurement Circuit for Single-Event Transient Sensitivity and Propagation in 130 nm Flash-Based FPGAs

    by Jinlong Ma, Xin Chen, Danfeng Qiu, Yingdan Jiang, Wenxun Wei, Zongguang Yu, Daiyin Zhu

    This paper proposes an on-chip time-to-digital converter (TDC) named pulse delay and capture circuit (PDCC), dedicated to single-event transient (SET) pulse measurement for radiation characterization of flash-based FPGAs. To address the inherent trade-offs of mainstream vernier delay line (VDL) and snapshot TDC schemes, the proposed PDCC employs a 16-stage single-chain self-triggering capture circuit with a SET indicator flip-flop, incorporates heterogeneous-cell ring-oscillator-based process-voltage-temperature (PVT) calibration, and avoids the need for resource-intensive first-in-first-out (FIFO) buffers. Implemented on a 130 nm A3PE600 flash-based FPGA, the PDCC achieves a nominal theoretical resolution of 640 ps and a nominal theoretical dynamic range of 0.64–10.24 ns, with 53.5% lower logic resource overhead than the VDL benchmark. Heavy-ion irradiation experiments validate the measurement capability and reveal asymmetric SET pulse propagation evolution characterized by positive-pulse broadening and negative-pulse attenuation, as well as sensitivity disparities among logic gates, which are attributed to the physical implementation of internal transistor networks within the VersaTile. A multi-criteria assessment based on the Simple Additive Weighting (SAW) method, evaluating resolution, dynamic range, logic resource overhead, and measured SET pulse width, yields an overall performance score (OPS) of 1.43, corresponding to a 43% higher score relative to the VDL baseline.