SZSizhu Zhou

Sizhu Zhou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sizhu Zhou has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A study on the influence of excitation parameters and sensor configuration on the performance of ultrasonic longitudinal and transverse wave bolt preload detection

    by Qilin Jiang, Sizhu Zhou, Ning Li, Yun Zeng, Hongting Che, Yi Feng

    Accurate measurement of bolt preload is crucial for the safe service life of engineering structures. Addressing issues such as the lack of theoretical basis for parameter selection, insufficient signal stability, and limited measurement accuracy in traditional longitudinal and transverse wave bolt preload testing, this study focuses on M36 × 3-350 high-strength bolts to a force–electric–acoustic multiphysics coupling model was established to investigate the mechanisms by which key parameters—such as excitation frequency, modulation period, piezoelectric transducer material, and excitation position—influence ultrasonic propagation characteristics and testing performance, and a parameter optimization method was proposed. Based on this, a combination of experimental and simulation methods was used to compare and validate the testing performance under optimized and non-optimized parameter configurations. The study indicates that the optimal excitation frequencies for longitudinal and transverse waves are 2 MHz and 1 MHz, respectively. When using a Hanning window modulation with a period of 5, an optimal balance between ultrasonic signal energy and the accuracy of first-arrival time identification is achieved; the transducer combination of PZT-4 for excitation and PZT-5 H for reception significantly improves the signal-to-noise ratio, while axial excitation helps suppress modal transition and enhance beam directivity; Under optimized parameter conditions, the measurement error for preload was controlled within 3%, whereas under non-optimized conditions, the error could reach 8%. The experimental results were in good agreement with numerical simulations. The proposed parameter optimization strategy can significantly improve the accuracy and stability of bolt preload detection using the longitudinal and transverse wave methods, providing a theoretical basis and technical support for engineering applications.

  • A new method for detecting bolt preload based on a combination of longitudinal and transverse ultrasonic waves

    by Qilin Jiang, Sizhu Zhou, Ning Li, Ruiling Li, Yun Zeng, Yi Feng

    Accurate measurement of bolt preload is critical for ensuring the performance and operational safety of mechanical structural connections. However, traditional modal-conversion-based longitudinal and transverse wave (T-wave) testing methods suffer from low T-wave excitation efficiency, insufficient signal stability, and limited feature-extraction accuracy. Taking an M36 × 3–350 mm bolt as the research subject, this study proposes an ultrasonic testing method based on direct excitation of T-waves using the D15 shear mode of a piezoelectric transducer. It simultaneously incorporates the t T / t L time ratio feature to characterize the preload and employs a cubic spline interpolation algorithm to reconstruct the discretely sampled signals, thereby improving peak localization accuracy and enhancing the precision of time-of-flight extraction. The research results indicate: (1) Compared to traditional modal conversion excitation methods, direct excitation via the D15 shear mode significantly improves T-wave excitation efficiency and modal purity. (2) The sound time ratio between transverse and longitudinal waves exhibits a significant linear negative correlation with bolt pretension and can serve as an effective feature parameter for characterizing changes in bolt pretension; numerical simulations agree well with experimental results, with the overall measurement error controlled within 3%. (3) The use of a cubic spline interpolation algorithm enables the raw sampling interval to be increased from 0.01 – 0.0001 μ s, improving the positioning accuracy of the first-arrival time of ultrasonic waves and enabling the effective identification of minute changes in preload. These research findings provide a theoretical foundation and technical support for bolt connection condition monitoring and intelligent structural health monitoring under complex operating conditions.