Yoongi Cho
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yoongi Cho has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Myungsoo Kim
Graduate School of Semiconductor Materials and Devices Engineering Ulsan National Institute of Science and Technology (UNIST) Ulsan South Korea
3 shared publications - Sungmoon Park
Graduate School of Semiconductor Materials and Devices Engineering Ulsan National Institute of Science and Technology (UNIST) Ulsan Republic of Korea
3 shared publications - Changwoo Pyo
Graduate School of Semiconductor Materials and Devices Engineering Ulsan National Institute of Science and Technology (UNIST) Ulsan 44919 South Korea
2 shared publications - Heein Yoon
Department of Electrical Engineering, Ulsan National Institute of Science and Technology, Ulsan, South Korea
2 shared publications - Seungchan Lee
Department of Electrical Engineering Ulsan National Institute of Science and Technology (UNIST) Ulsan 44919 South Korea
2 shared publications Changmin An
Department of Electrical Engineering Ulsan National Institute of Science and Technology (UNIST) Ulsan South Korea
1 shared publication
Latest Publications
Monolayer h‐BN RF Switch Toward Monolithic Inductor Switching in Wide‐Tuning‐Range LC ‐VCOs
Next‐generation wireless systems demand monolithic three‐dimensional (3D) system‐on‐chip architectures to overcome planar scaling limits and reduce interconnect delays. Realizing this back‐end‐of‐line (BEOL) integration on complementary metal‐oxide‐semiconductor (CMOS) platforms requires ultracompact, high‐performance radio‐frequency (RF) switches. Here, we present a non‐volatile RF switch based on a monolayer hexagonal boron nitride (h‐BN) memristor employing an Ag/h‐BN/Ag structure. The device exhibits a low SET voltage of 1.11 V and stable endurance exceeding 500 cycles. At 20 GHz, it achieves an insertion loss of 0.81 dB and an isolation of 32.91 dB, enabled by a low on‐resistance ( R ON ) of 4.3 Ω and an ultralow off‐capacitance ( C OFF ) of 1.8 fF, corresponding to a cut‐off frequency ( F CO ) of 20.5 THz. To verify its feasibility at the circuit level, the h‐BN RF switch was applied to an LC ‐type voltage‐controlled oscillator ( LC ‐VCO), whose inductance can be reconfigured. The simulation results indicate that modulating the switch state and thereby changing the effective inductance enables wideband frequency tuning from 1.44 to 7.45 GHz, corresponding to a frequency tuning range (FTR) of 135%. These results verify the feasibility of the atomically thin h‐BN RF switch for inductor switching in reconfigurable LC ‐VCOs, presenting a promising route toward miniaturized high‐frequency circuit designs.
Monolayer h‐BN RF Switch Toward Monolithic Inductor Switching in Wide‐Tuning‐Range LC ‐VCOs
Next‐generation wireless systems demand monolithic three‐dimensional (3D) system‐on‐chip architectures to overcome planar scaling limits and reduce interconnect delays. Realizing this back‐end‐of‐line (BEOL) integration on complementary metal‐oxide‐semiconductor (CMOS) platforms requires ultracompact, high‐performance radio‐frequency (RF) switches. Here, we present a non‐volatile RF switch based on a monolayer hexagonal boron nitride (h‐BN) memristor employing an Ag/h‐BN/Ag structure. The device exhibits a low SET voltage of 1.11 V and stable endurance exceeding 500 cycles. At 20 GHz, it achieves an insertion loss of 0.81 dB and an isolation of 32.91 dB, enabled by a low on‐resistance ( R ON ) of 4.3 Ω and an ultralow off‐capacitance ( C OFF ) of 1.8 fF, corresponding to a cut‐off frequency ( F CO ) of 20.5 THz. To verify its feasibility at the circuit level, the h‐BN RF switch was applied to an LC ‐type voltage‐controlled oscillator ( LC ‐VCO), whose inductance can be reconfigured. The simulation results indicate that modulating the switch state and thereby changing the effective inductance enables wideband frequency tuning from 1.44 to 7.45 GHz, corresponding to a frequency tuning range (FTR) of 135%. These results verify the feasibility of the atomically thin h‐BN RF switch for inductor switching in reconfigurable LC ‐VCOs, presenting a promising route toward miniaturized high‐frequency circuit designs.
- 16 November 2026
- Published by Royal Society of Chemistry (RSC) in Materials Horizons
- Vol. 13 (22) , 11229-11241
Solution-processed polyimide memristors for high-performance and reconfigurable T-type radio-frequency routing
Solution-processed polyimide bridges memristive transport and RF functionality, enabling low-parasitic nonvolatile switching, flexible operation, and monolithic T-type routing.
- 16 November 2026
- Published by Royal Society of Chemistry (RSC) in Materials Horizons
- Vol. 13 (22) , 11229-11241
Solution-processed polyimide memristors for high-performance and reconfigurable T-type radio-frequency routing
Solution-processed polyimide bridges memristive transport and RF functionality, enabling low-parasitic nonvolatile switching, flexible operation, and monolithic T-type routing.
- Open Access
- 21 October 2026
- Published by Wiley in Advanced Functional Materials
Low‐Flicker‐Noise MoS 2 Transistors Enabled by High‐ κ Rare‐Earth Oxychlorides for Mixed‐Signal Electronics
The trade‐off between gate dielectric constant and interface quality limits two‐dimensional (2D) analog and mixed‐signal electronics because trap‐mediated 1/ f noise from amorphous oxides degrades signal fidelity. Here, single‐crystalline rare‐earth oxychlorides (REOCl; LaOCl and GdOCl) are employed as Cl‐terminated crystalline high‐ κ dielectrics that form atomically abrupt van der Waals interfaces with MoS 2 . MoS 2 /REOCl transistors exhibit near‐thermal‐limit switching, with minimum one‐decade‐averaged subthreshold swings of 65.7 and 63.2 mV dec −1 for LaOCl and GdOCl, with ultralow hysteresis and suppressed low‐frequency noise. Carrier‐number‐fluctuation analysis of two independently measured devices per dielectric yields effective noise‐derived interface trap densities of 1.15–1.94 × 10 10 cm −2 eV −1 , approaching the hexagonal boron nitride regime while retaining high‐ κ electrostatic coupling. Channel‐area‐scaled normalized 1/ f noise remains up to two orders of magnitude below amorphous SiO 2 /Al 2 O 3 /HfO 2 controls, with on‐state S I / I D 2 reaching ∼10 −10 Hz −1 . A Samsung 28 nm high‐ κ /metal‐gate reference process design kit sensitivity analysis, with only the flicker‐noise coefficient varied, indicates reduced voltage‐controlled oscillator phase noise and phase‐locked‐loop jitter and an effective‐number‐of‐bits improvement of up to 1.45 bits in passive noise‐shaping successive‐approximation‐register analog‐to‐digital converters. These results establish REOCl as a trap‐poor high‐ κ dielectric platform for low‐noise 2D electronics and illustrate the mixed‐signal relevance of reduced transistor flicker noise.
- 21 October 2026
- Published by Wiley in Advanced Functional Materials
Open AccessLow‐Flicker‐Noise MoS 2 Transistors Enabled by High‐ κ Rare‐Earth Oxychlorides for Mixed‐Signal Electronics
The trade‐off between gate dielectric constant and interface quality limits two‐dimensional (2D) analog and mixed‐signal electronics because trap‐mediated 1/ f noise from amorphous oxides degrades signal fidelity. Here, single‐crystalline rare‐earth oxychlorides (REOCl; LaOCl and GdOCl) are employed as Cl‐terminated crystalline high‐ κ dielectrics that form atomically abrupt van der Waals interfaces with MoS 2 . MoS 2 /REOCl transistors exhibit near‐thermal‐limit switching, with minimum one‐decade‐averaged subthreshold swings of 65.7 and 63.2 mV dec −1 for LaOCl and GdOCl, with ultralow hysteresis and suppressed low‐frequency noise. Carrier‐number‐fluctuation analysis of two independently measured devices per dielectric yields effective noise‐derived interface trap densities of 1.15–1.94 × 10 10 cm −2 eV −1 , approaching the hexagonal boron nitride regime while retaining high‐ κ electrostatic coupling. Channel‐area‐scaled normalized 1/ f noise remains up to two orders of magnitude below amorphous SiO 2 /Al 2 O 3 /HfO 2 controls, with on‐state S I / I D 2 reaching ∼10 −10 Hz −1 . A Samsung 28 nm high‐ κ /metal‐gate reference process design kit sensitivity analysis, with only the flicker‐noise coefficient varied, indicates reduced voltage‐controlled oscillator phase noise and phase‐locked‐loop jitter and an effective‐number‐of‐bits improvement of up to 1.45 bits in passive noise‐shaping successive‐approximation‐register analog‐to‐digital converters. These results establish REOCl as a trap‐poor high‐ κ dielectric platform for low‐noise 2D electronics and illustrate the mixed‐signal relevance of reduced transistor flicker noise.