TMTatsuya Meguro

Tatsuya Meguro

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Tatsuya Meguro has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Designing and fabrication of 4H-SiC neutron sensors for boron neutron capture therapy

    by Vu Thi Ha, Tatsuya Meguro, Kazutoshi Kojima, Hiroki Tanaka, Shin-Ichiro Kuroki

    In this work, 4H-SiC neutron sensors (NSs) for boron neutron capture therapy were designed, fabricated, and tested under ultraviolet (UV) light and neutron irradiation. A pinned photodiode (PPD) structure and a parasitic bipolar junction transistor were designed for the NS region. A large neutron conversion layer of 500 µm × 500 µm was formed on the PPD area by 10 B ions implanted into a 700 nm Al layer. The output characteristics under UV light tests have demonstrated the functional operation of the 4T-active pixel sensor structure of SiC NSs. No significant degradation was observed under the E-3 tube, with a total neutron fluence of 1.8 × 10 9 n cm −2 . The results, which were obtained under the heavy water neutron irradiation facility condition with a high neutron flux in the range of 1×10 9 n c m − 2 s − 1 and a cycle of 1.0 s, demonstrated the neutron detection capability of the 4H-SiC NS prototypes, despite signs of degradation due to neutron-induced damage and the TID effects.

  • Open Access

    Thermal Stability of Gate Driver Circuits Based on 4H-SiC MOSFETs at 300°C for High-Power Applications

    by Vuong Van Cuong, Tatsuya Meguro, Seiji Ishikawa, Tomonori Maeda, Hiroshi Sezaki, Shin-Ichiro Kuroki

    The operation and reliability of gate driver circuits based on 4H-SiC MOSFETs at temperatures up to 300∘ C were reported. Due to the advantages of 4H-SiC MOSFETs, the driver circuit can overcome limitations in complicated circuit design and power dissipation associated with SiC BJT-based technology. Additionally, the stability of implanted 4H-SiC resistors can address the reliability issues of SiC CMOS-based driver circuits, which are caused by the instability in the threshold voltage of P-channel SiC MOSFETs. In this study, the switching characteristics of the gate driver circuit were improved when the ambient temperature increased. The decrease of threshold voltage and increase of carrier mobility of the 4H-SiC MOSFETs may account for the improvement in switching characteristics of the gate driver circuit. The output signal of the gate driver circuit still showed proper characteristics after 600 min of continuous operation at 300∘ C in an air ambient. These results indicate that the gate driver circuit based on 4H-SiC MOSFET technology is promising to apply for high power applications.


  • Thermal stability of TiN gate electrode for 4H-SiC MOSFETs and integrated circuits

    by Vuong Van Cuong, Tatsuya Meguro, Seiji Ishikawa, Tomonori Maeda, Hiroshi Sezaki, Shin-Ichiro Kuroki

    In this research, the thermal stability of single-stage amplifiers based on a 4H-SiC MOSFET with a TiN gate electrode was investigated. The results show that after 100 h aging at 400 °C in N2 ambient, the amplifier maintained good performance with stable voltage gain. The thermal stability of the amplifier is attributed to the stability of Ni/Nb/4H-SiC source/drain ohmic contact, implanted load resistor, and MOS structure with the TiN gate electrode. The results obtained from the 4H-SiC MOS structure show that the interface trap density at the SiO2/SiC decreases during the aging process. While the gate leakage current of the capacitor based on the Al gate electrode increases, it remains stable in structures with TiN gate electrodes after 100 h aging. The results obtained in this study indicate that TiN is promising for the gate electrode of 4H-SiC MOSFETs for high-temperature applications.


  • Open Access

    4H-SiC 64 pixels CMOS image sensors with 3T/4T-APS arrays

    by Tatsuya Meguro, Masayuki Tsutsumi, Akinori Takeyama, Takeshi Ohshima, Yasunori Tanaka, Shin-Ichiro Kuroki

    For radiation-hardened CMOS image sensors (CIS), 4H-SiC 64 pixel array CIS were developed, and real time imaging with an operation frequency of 30 Hz was demonstrated. Two types of pixel arrays with a 3-transistor active pixel sensor (3T-APS) and a 4-transistor active pixel sensor (4T-APS) were fabricated with SiC MOSFETs, UV photodiodes and 3-layered Al interconnections. The SiC pixel arrays were combined with peripheral circuits and an optical lens, and SiC 64 pixel CIS with 3T-/4T-APS arrays were developed.


  • Open Access

    Study of interface-trap and near-interface-state distribution in a 4H-SiC MOS capacitor with the full-distributed circuit model

    by Vuong Van Cuong, Kaho Koyanagi, Tatsuya Meguro, Seiji Ishikawa, Tomonori Maeda, Hiroshi Sezaki, Shin-Ichiro Kuroki

    In this research, the full-distributed circuit model was used to classify the contribution of interface traps (ITs) and near-interface states to the electrical characteristics of a 4H-SiC MOS capacitor over a wide range of operation. By fitting the measured capacitance and conductance at a certain value of applied gate voltage when the frequency varied from 1 kHz to 1 MHz, the density of both near-interface states and ITs was determined. The results reveal that, at RT, the frequency dispersion of capacitance in the depletion condition is mainly caused by the contribution of ITs. Nevertheless, in the strong accumulation condition, near-interface states become dominant for the frequency dispersion of the capacitance. Furthermore, the full-distributed circuit model also successfully explained the electrical characteristics of a 4H-SiC MOS capacitor when operating at 500 °C.


  • Integrated Fabrication Process of Si Microcantilever Using TMAH Solution With Planar Molybdenum Mask

    by Lia Aprilia, Tatsuya Meguro, Ratno Nuryadi, Tetsuo Tabei, Hidenori Mimura, Shin-Ichiro Kuroki

    The anisotropic etching release of a silicon microcantilever structure becomes challenging when it has embedded metal layers. We integrated the anisotropic wet silicon etching and etch-back method for the microcantilever releasing process in a silicon-on-insulator (SOI) wafer using a planar molybdenum (Mo)-based mask. Mo mask, which has good stability on morphology in tetramethylammonium hydroxide (TMAH) etchant as well as electrical characteristics, was employed to protect the metal resistor on the cantilever surface from TMAH etchant during silicon etching. To obtain a planar topography for the Mo mask, we applied a sequence of three etch-back processes using ZEP 520A resist, which has a similar etching rate to the non-doped silicate glass (NSG) layer in the plasma CF $_{4}$ :H $_{2}$ gas (40:1). After surface planarization, the angle of the indentation region (metal edge boundary area) was about 180 $^{\circ}$ (almost flat), thus avoiding cracks in the Mo mask layer. As a result, the cantilever with a metal resistor was successfully released from the silicon substrate by our proposed method. Therefore, this process promises a silicon microcantilever fabrication method without backside alignment masks, relatively low temperature, and complementary metal-oxide semiconductor (CMOS) compatibility for chemical and bio-sensor applications.


  • Open Access

    Integrated 4H-SiC Photosensors With Active Pixel Sensor-Type Circuits for MGy-Class Radiation Hardened CMOS UV Image Sensor

    by Masayuki Tsutsumi, Tatsuya Meguro, Akinori Takeyama, Takeshi Ohshima, Yasunori Tanaka, Shin-Ichiro Kuroki

    For radiation-hardened CMOS image sensor (CIS), 4H-SiC photosensors with active pixel sensor (APS)-type circuits were developed and demonstrated. The dark current of 4H-SiC photodiodes was <2 nA/cm2. The spectral sensitivity characteristics were also evaluated in the wavelength from 200 nm to 400 nm. The maximal quantum efficiency was 63% at 270 nm. The photosensors with APS type circuits showed high responses to UV light, demonstrating their operation. High gamma-ray dose experiments were also carried out. The dark current after 2 MGy (SiO2) irradiation was 25 nA/cm2. The photosensors with APS-type were successfully working after 2 MGy exposure.


  • Adsorption structure deteriorating negative electron affinity under the H2O environment

    by M. Kashima, S. Ishiyama, D. Sato, A. Koizumi, H. Iijima, T. Nishitani, Y. Honda, H. Amano, T. Meguro

    Photocathodes with negative electron affinity (NEA) characteristics have various advantages, such as small energy spread, high spin polarization, and ultrashort pulsing. Nitride semiconductors, such as GaN and InGaN, are promising materials for NEA photocathodes because their lifetimes are longer than those of other materials. In order to further prolong the lifetime, it is important to better understand the deterioration of NEA characteristics. The adsorption of residual gases and back-bombardment by ionized residual gases shorten the lifetime. Among the adsorbed residual gases, H2O has a significant influence. However, the adsorption structures produced by the reaction with H2O are not comprehensively studied so far. In this study, we investigated adsorption structures that deteriorated the NEA characteristics by exposing InGaN and GaAs to an H2O environment and discussed the differences in their lifetimes. By comparing the temperature-programmed desorption curves with and without H2O exposure, the generation of CsOH was confirmed. The desorption of CsOH demonstrated different photoemission behaviors between InGaN and GaAs results. InGaN recovered its NEA characteristics, whereas GaAs did not. Considering the Cs desorption spectra, it is difficult for an NEA surface on InGaN to change chemically, whereas that for GaAs changes easily. The chemical reactivity of the NEA surface is different for InGaN and GaAs, which contributes to the duration of photoemission. We have attempted to prolong the lifetime of InGaN by recovering its NEA characteristics. We found that InGaN with NEA characteristics can be reused easily without thermal treatment at high temperatures.


  • Open Access

    Hybrid Pixels With Si Photodiode and 4H-SiC MOSFETs Using Direct Heterogeneous Bonding Toward Radiation Hardened CMOS Image Sensors

    by Tatsuya Meguro, Akinori Takeyama, Takeshi Ohshima, Yasunori Tanaka, Shin-Ichiro Kuroki

    For radiation hardened image sensors, a Silicon-On-Insulator (SOI) -Si/ 4H-SiC hybrid pixel device was developed. The hybrid pixel device consists of one Si photodiode and three 4H-SiC nMOSFETs. At fabrication, SOI substrate was directly bonded on 4H-SiC substrate via SiO2. After bonding, the base silicon substrate and Buried Oxide (BOX) were removed by TMAH wet-etching. By using this SOI-Si/ 4H-SiC substrate, the SOI-Si photodiodes and 4H-SiC nMOSFETs were integrated in the same substrate. As a result, a response of the SOI-Si/ 4H-SiC hybrid pixel device to light illumination was successfully demonstrated.


  • Amplifier Based on 4H-SiC MOSFET Operation at 500 °C for Harsh Environment Applications

    by Vuong Van Cuong, Tatsuya Meguro, Seiji Ishikawa, Tomonori Maeda, Hiroshi Sezaki, Shin-Ichiro Kuroki

    Successful operation of 4H-silicon carbide (SiC) MOSFET and integrated electronic circuit based on 4H-SiC MOSFET is reported at temperature up to $500~^{\circ }\text{C}$ in air. The high-temperature operation of the integrated circuit (IC) based on 4H-SiC MOSFET strongly depends on the reliability of metal/SiC contact. Based on the transfer length method (TLM), the Ni/Nb/n-type 4H-SiC junction exhibits ohmic behavior with specific contact resistance of $1.86\times 10^{-{4}}\,\, \Omega \cdot $ cm 2 when operating at $500~^{\circ }\text{C}$ . In contrast, the voltage gain of the amplifier is strongly governed by the variation of carrier mobility of the 4H-SiC MOSFET when temperature varies from room temperature to $500~^{\circ }\text{C}$ . The experimental results show that, when the temperature is increased from $20~^{\circ }\text{C}$ to $300~^{\circ }\text{C}$ , the amplifier gain of the IC increased from 23.8 to 153.0. Though the voltage gain decreases when the temperature increases above $300~^{\circ }\text{C}$ , it is still higher than 50 at $500~^{\circ }\text{C}$ . These results indicate that integrated electronic circuits based on this 4H-SiC MOSFET technology could be potentially used for harsh environment applications.