Vladimir N. Blinkov
Vladimir N. Blinkov has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Holger Wolff
Gesellschaft für Anlagen- und Reaktorsicherheit (GRS) mbH, Kurfürstendamm 200, 10719 Berlin, Germany
1 shared publicationMikhail V. Davydov
Thermo-Hydraulics Division, Electrogorsk Research and Engineering Center for Safety of Nuclear Power Plants, Saint Constantine Street 6, Electrogorsk, Moscow 142530, Russia
1 shared publicationOleg I. Melikhov
Thermo-Hydraulics Division, Electrogorsk Research and Engineering Center for Safety of Nuclear Power Plants, Saint Constantine Street 6, Electrogorsk, Moscow 142530, Russia
1 shared publicationOwen C. Jones Jr.
1 shared publication- Siegfried Arndt
Gesellschaft für Anlagen- und Reaktorsicherheit (GRS) mbH, Kurfürstendamm 200, 10719 Berlin, Germany
1 shared publication - Vladimir I. Melikhov
National Research University Moscow Power Engineering Institute, Moscow, Russia
1 shared publication
Latest Publications
- 1 January 2023
- Published by Begell House Inc. Publishers
- p. 637-666
NUCLEATION AND FLASHING OF INITIALLY SUBCOOLED LIQUIDS FLOWING IN NOZZLES: 2. COMPARISON WITH EXPERIMENTS USING A 5-EQUATION MODEL FOR VAPOR VOID DEVELOPMENT
A quasi-one-dimensional, five-equation model has been developed on a microcomputer to calculate the behavior of flowing, initially subcooled, flashing liquids. Equations for mixture and vapor mass conservation, mixture momentum conservation, liquid energy conservation, and bubble transport were discretized and linearized semi-implicitly, and solved using a successive iteration Newton method. Closure was obtained through simple constitutive equations for friction and spherical bubble growth, and a new nucleation model for wall nucleation in small nozzles combined with an existing model for bulk nucleation in large geometries. Good qualitative and quantitative agreement with experiment confirms the adequacy of the nucleation models in determining both initial size and number density of nuclei. It is shown that bulk nucleation becomes important as the volume-to-surface ratio of the geometry is increased.
- 1 January 2023
- Published by Begell House Inc. Publishers
- p. 637-666
NUCLEATION AND FLASHING OF INITIALLY SUBCOOLED LIQUIDS FLOWING IN NOZZLES: 2. COMPARISON WITH EXPERIMENTS USING A 5-EQUATION MODEL FOR VAPOR VOID DEVELOPMENT
A quasi-one-dimensional, five-equation model has been developed on a microcomputer to calculate the behavior of flowing, initially subcooled, flashing liquids. Equations for mixture and vapor mass conservation, mixture momentum conservation, liquid energy conservation, and bubble transport were discretized and linearized semi-implicitly, and solved using a successive iteration Newton method. Closure was obtained through simple constitutive equations for friction and spherical bubble growth, and a new nucleation model for wall nucleation in small nozzles combined with an existing model for bulk nucleation in large geometries. Good qualitative and quantitative agreement with experiment confirms the adequacy of the nucleation models in determining both initial size and number density of nuclei. It is shown that bulk nucleation becomes important as the volume-to-surface ratio of the geometry is increased.
- Open Access
- 17 November 2011
- Published by Wiley in Science and Technology of Nuclear Installations
- Vol. 2012, 1-20
Experimental Studies for the VVER-440/213 Bubble Condenser System for Kola NPP at the Integral Test Facility BC V-213
In the frame of Tacis Project R2.01/99, which was running from 2003 to 2005, the bubble condenser system of Kola NPP (unit 3) was qualified at the integral test facility BC V-213. Three LB LOCA tests, two MSLB tests, and one SB LOCA test were performed. The appropriate test scenarios for BC V-213 test facility, modeling accidents in the Kola NPP unit 3, were determined with pretest calculations. Analysis of test results has shown that calculated initial conditions and test scenarios were properly reproduced in the tests. The detailed posttest analysis of the tests performed at BC V-213 test facility was aimed to validate the COCOSYS code for the calculation of thermohydraulic processes in the hermetic compartments and bubble condenser. After that the validated COCOSYS code was applied to NPP calculations for Kola NPP (unit 3). Results of Tacis R2.01/99 Project confirmed the bubble condenser functionality during large and small break LOCAs and MSLB accidents. Maximum loads were reached in the LB LOCA case. No condensation oscillations were observed.
- 17 November 2011
- Published by Wiley in Science and Technology of Nuclear Installations
- Vol. 2012, 1-20
Open AccessExperimental Studies for the VVER-440/213 Bubble Condenser System for Kola NPP at the Integral Test Facility BC V-213
In the frame of Tacis Project R2.01/99, which was running from 2003 to 2005, the bubble condenser system of Kola NPP (unit 3) was qualified at the integral test facility BC V-213. Three LB LOCA tests, two MSLB tests, and one SB LOCA test were performed. The appropriate test scenarios for BC V-213 test facility, modeling accidents in the Kola NPP unit 3, were determined with pretest calculations. Analysis of test results has shown that calculated initial conditions and test scenarios were properly reproduced in the tests. The detailed posttest analysis of the tests performed at BC V-213 test facility was aimed to validate the COCOSYS code for the calculation of thermohydraulic processes in the hermetic compartments and bubble condenser. After that the validated COCOSYS code was applied to NPP calculations for Kola NPP (unit 3). Results of Tacis R2.01/99 Project confirmed the bubble condenser functionality during large and small break LOCAs and MSLB accidents. Maximum loads were reached in the LB LOCA case. No condensation oscillations were observed.