Kouadio Marc Cyril
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kouadio Marc Cyril has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Adjoumani Rodrigue Kouakou
Laboratoire de Thermodynamique et de Physico-Chimie du Milieu (LTPCM), UFR Sciences Fondamentales Appliquées, Université Nangui Abrogoua, 02 BP 801 Abidjan 02, Côte d’Ivoire
2 shared publications Kouakou Adjoumani Rodrigue
2 shared publicationsSeka Ossey Clovis
2 shared publicationsAbolle Abolle
1 shared publication- Ahissan Donatien Ehouman
Laboratoire de Thermodynamique et Physico-Chimie du Milieu, UFR SFA, Université Nangui Abrogoua, 02 BP 801 Abidjan 02, Côte-d’Ivoire
1 shared publication Aka Boko
1 shared publication
Latest Publications
- 22 August 2025
- Published by Sciencedomain International in Asian Journal of Chemical Sciences
- Vol. 15 (5) , 31-49
Reduction of Carbon Monoxide in Biogas Using an Activated Carbon Filter Produced from Rubber Tree Branches
Biogas is a renewable energy source that can significantly reduce fossil fuel consumption. However, raw biogas often contains carbon monoxide (CO), a toxic gas that compromises safety and reduces combustion efficiency. To address this challenge, this research investigates the impact of various factors of the activated carbon synthesis from rubber tree branches (the precursor and activating agent types, impregnation time) on its yield and physicochemical characteristics and develop on the base of such study results an effective method to reduce carbon monoxide (CO) concentration in biogas using the indicated activated carbon. The research investigates the influence of key synthesis parameters on the yield and physicochemical characteristics of the carbon. A full factorial design was used to optimize these factors. The activated carbon produced from HK (GT1) rubber clone and activated with K₂CO₃ achieved a consistent 90% CO removal efficiency, even at high initial CO concentrations, with adsorption best described by the Langmuir and Dubinin-Radushkevich isotherms. Compared to prior studies that mainly targeted hydrogen sulfide or other impurities in biogas purification, our work uniquely focuses on CO removal and demonstrates superior adsorption performance using a low-cost, renewable biomass-derived activated carbon. The use of a renewable waste biomass as precursor and the high efficiency of the synthesized adsorbent underscore the study’s originality. This work provides a cost-effective and scalable solution for biogas purification, contributing to improved energy performance and sustainable waste management practices.
- 22 August 2025
- Published by Sciencedomain International in Asian Journal of Chemical Sciences
- Vol. 15 (5) , 31-49
Reduction of Carbon Monoxide in Biogas Using an Activated Carbon Filter Produced from Rubber Tree Branches
Biogas is a renewable energy source that can significantly reduce fossil fuel consumption. However, raw biogas often contains carbon monoxide (CO), a toxic gas that compromises safety and reduces combustion efficiency. To address this challenge, this research investigates the impact of various factors of the activated carbon synthesis from rubber tree branches (the precursor and activating agent types, impregnation time) on its yield and physicochemical characteristics and develop on the base of such study results an effective method to reduce carbon monoxide (CO) concentration in biogas using the indicated activated carbon. The research investigates the influence of key synthesis parameters on the yield and physicochemical characteristics of the carbon. A full factorial design was used to optimize these factors. The activated carbon produced from HK (GT1) rubber clone and activated with K₂CO₃ achieved a consistent 90% CO removal efficiency, even at high initial CO concentrations, with adsorption best described by the Langmuir and Dubinin-Radushkevich isotherms. Compared to prior studies that mainly targeted hydrogen sulfide or other impurities in biogas purification, our work uniquely focuses on CO removal and demonstrates superior adsorption performance using a low-cost, renewable biomass-derived activated carbon. The use of a renewable waste biomass as precursor and the high efficiency of the synthesized adsorbent underscore the study’s originality. This work provides a cost-effective and scalable solution for biogas purification, contributing to improved energy performance and sustainable waste management practices.
- 20 August 2025
- Published by Sciencedomain International in International Research Journal of Pure and Applied Chemistry
- Vol. 26 (5) , 1-9
Zero-Order Kinetic Modeling of Methane Emissions from Organic Waste: A Case Study of the Abidjan Landfill System
The rapid urbanization and population growth of Abidjan, the economic capital of Côte d'Ivoire, have led to a significant increase in the generation of municipal solid waste (MSW), a large portion of which is biodegradable. Inefficient waste disposal in uncontrolled landfills results in uncontrolled methane (CH₄) emissions, a greenhouse gas with a global warming potential 28 times greater than that of carbon dioxide. Managing these methane emissions presents a major challenge for the environmental and energy sustainability of the city. This study proposes the application of a simplified kinetic model to predict the energy potential of waste in Abidjan, specifically focusing on the Kossihouen landfill. In this context, the term “simplified kinetic model” refers to a zero-order approach that assumes a constant methane production rate, independent of the substrate concentration, making it suitable for contexts where detailed waste degradation data is scarce. Due to the difficulty of obtaining experimental data in tropical contexts, the simplified model, which assumes a constant methane production rate independent of substrate concentration, was chosen as a practical and effective solution for estimating methane emissions. The results demonstrate that the waste from the Kossihouen landfill could generate an annual electrical output of 15.34 MW, sufficient to supply energy to 92,000 people in 2021. These empirical results were compared with theoretical estimates from other kinetic models, showing consistent trends but highlighting that theoretical maximum values cannot be fully achieved in practice due to recovery limitations. Furthermore, this energy recovery leads to a reduction in greenhouse gas emissions. This approach provides local policymakers and energy planners with a valuable tool for assessing the feasibility of biogas recovery and sustainable waste management projects. Additionally, the study lays the foundation for future research on the adaptation of simplified models in other African contexts facing similar challenges.
- 20 August 2025
- Published by Sciencedomain International in International Research Journal of Pure and Applied Chemistry
- Vol. 26 (5) , 1-9
Zero-Order Kinetic Modeling of Methane Emissions from Organic Waste: A Case Study of the Abidjan Landfill System
The rapid urbanization and population growth of Abidjan, the economic capital of Côte d'Ivoire, have led to a significant increase in the generation of municipal solid waste (MSW), a large portion of which is biodegradable. Inefficient waste disposal in uncontrolled landfills results in uncontrolled methane (CH₄) emissions, a greenhouse gas with a global warming potential 28 times greater than that of carbon dioxide. Managing these methane emissions presents a major challenge for the environmental and energy sustainability of the city. This study proposes the application of a simplified kinetic model to predict the energy potential of waste in Abidjan, specifically focusing on the Kossihouen landfill. In this context, the term “simplified kinetic model” refers to a zero-order approach that assumes a constant methane production rate, independent of the substrate concentration, making it suitable for contexts where detailed waste degradation data is scarce. Due to the difficulty of obtaining experimental data in tropical contexts, the simplified model, which assumes a constant methane production rate independent of substrate concentration, was chosen as a practical and effective solution for estimating methane emissions. The results demonstrate that the waste from the Kossihouen landfill could generate an annual electrical output of 15.34 MW, sufficient to supply energy to 92,000 people in 2021. These empirical results were compared with theoretical estimates from other kinetic models, showing consistent trends but highlighting that theoretical maximum values cannot be fully achieved in practice due to recovery limitations. Furthermore, this energy recovery leads to a reduction in greenhouse gas emissions. This approach provides local policymakers and energy planners with a valuable tool for assessing the feasibility of biogas recovery and sustainable waste management projects. Additionally, the study lays the foundation for future research on the adaptation of simplified models in other African contexts facing similar challenges.
- Open Access
- 6 June 2025
- Published by Oriental Scientific Publishing Company in Oriental Journal of Chemistry
- Vol. 41 (3) , 816-824
Anaerobic Valorisation of Kplala (Corchorus olitorius) Residues through Co-digestion with Leftover Food for Enhanced Biogas Generation
The organic-rich waste from Abidjan District has high methane and carbon dioxide emission potential, posing environmental risks. This study aims to assess the impact of incorporating kplala, a leafy biomass, on the biogas yield and methane content derived from food waste. Batch experiments were conducted under mesophilic conditions (37 °C), testing various mixing ratios of food waste and kplala. This approach achieved a specific biomethane yield of 327.57 ± 4 mL/gVS, corresponding to an annual electricity generation with a maximum potential of 23 megawatts. This finding is likely due to a more balanced nutrient profile and increased biodegradability of the co-substrate mixture. Furthermore, the combined treatment of these organic wastes presents a promising and eco-friendly strategy for urban waste management, while simultaneously supporting renewable energy generation. These outcomes highlight the potential for developing tailored anaerobic digestion solutions suitable for the Ivorian context.
- 6 June 2025
- Published by Oriental Scientific Publishing Company in Oriental Journal of Chemistry
- Vol. 41 (3) , 816-824
Open AccessAnaerobic Valorisation of Kplala (Corchorus olitorius) Residues through Co-digestion with Leftover Food for Enhanced Biogas Generation
The organic-rich waste from Abidjan District has high methane and carbon dioxide emission potential, posing environmental risks. This study aims to assess the impact of incorporating kplala, a leafy biomass, on the biogas yield and methane content derived from food waste. Batch experiments were conducted under mesophilic conditions (37 °C), testing various mixing ratios of food waste and kplala. This approach achieved a specific biomethane yield of 327.57 ± 4 mL/gVS, corresponding to an annual electricity generation with a maximum potential of 23 megawatts. This finding is likely due to a more balanced nutrient profile and increased biodegradability of the co-substrate mixture. Furthermore, the combined treatment of these organic wastes presents a promising and eco-friendly strategy for urban waste management, while simultaneously supporting renewable energy generation. These outcomes highlight the potential for developing tailored anaerobic digestion solutions suitable for the Ivorian context.
- Open Access
- 27 June 2024
- Published by Oriental Scientific Publishing Company in Oriental Journal of Chemistry
- Vol. 40 (3) , 666-672
Mitigating Corrosion in Activated Carbon Purified Biogas: A Case Study of Copper and Aluminum Metals
The objective of this study is to investigate the potential reduction in corrosion of aluminum and copper metals when exposed to biogas purified by activated carbon derived from cashew branches. Both aluminum and copper metals were subjected to raw and purified biogas, and their corrosion rates were analyzed using the gravimetric method. The results revealed that the corrosion rate of both metals increased over time when exposed to unfiltered biogas. However, a notable reduction in corrosion rate was observed when the metals were exposed to biogas filtered with activated carbon. This suggests that activated carbon derived from cashew branches could effectively mitigate the corrosive effects of hydrogen sulfide in biogas. Additionally, the study found that aluminum exhibited greater resistance to corrosion compared to copper when exposed to filtered biogas. This research on green inhibitors introduces novel approaches, particularly in utilizing activated carbon from cashew branches for biogas purification, offering a promising strategy to mitigate its corrosive nature. Furthermore, the evaluation of this filtration method's efficacy in protecting aluminum and copper metals underscores its potential significance in corrosion prevention within biogas systems.
- 27 June 2024
- Published by Oriental Scientific Publishing Company in Oriental Journal of Chemistry
- Vol. 40 (3) , 666-672
Open AccessMitigating Corrosion in Activated Carbon Purified Biogas: A Case Study of Copper and Aluminum Metals
The objective of this study is to investigate the potential reduction in corrosion of aluminum and copper metals when exposed to biogas purified by activated carbon derived from cashew branches. Both aluminum and copper metals were subjected to raw and purified biogas, and their corrosion rates were analyzed using the gravimetric method. The results revealed that the corrosion rate of both metals increased over time when exposed to unfiltered biogas. However, a notable reduction in corrosion rate was observed when the metals were exposed to biogas filtered with activated carbon. This suggests that activated carbon derived from cashew branches could effectively mitigate the corrosive effects of hydrogen sulfide in biogas. Additionally, the study found that aluminum exhibited greater resistance to corrosion compared to copper when exposed to filtered biogas. This research on green inhibitors introduces novel approaches, particularly in utilizing activated carbon from cashew branches for biogas purification, offering a promising strategy to mitigate its corrosive nature. Furthermore, the evaluation of this filtration method's efficacy in protecting aluminum and copper metals underscores its potential significance in corrosion prevention within biogas systems.