Calibration of thermocouple-based scanning thermal microscope in active mode (2ω method)
- 1 November 2019
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 90 (11) , 114901
Abstract
We present a procedure dedicated to the calibration of a scanning thermal microscopy probe operated in an active mode and a modulated regime especially for the measurement of solid material thermal conductivities. The probe used is a microthermocouple wire mounted on a quartz tuning fork. Measurements on reference samples are performed successively in vacuum and ambient air conditions revealing a clear difference in the dependence of the thermal interaction between the probe and the sample on the sample properties. Analytical modeling based on the resolution of the heat equation in the wire probe and a description of the thermal interaction using a network of thermal conductances are used to fit experimental data and analyze this difference. We have experimentally verified that the effective thermal contact radius of the probe tip depends on the sample thermal conductivity in ambient conditions, whereas it remains constant in vacuum. We have defined the measurement range of the technique based on the decrease in the probe sensitivity at high thermal conductivities. Considering the experimental noise of our electrical device, it is shown that the maximum measurable value of thermal conductivity is near 23 W m−1 K−1 in vacuum and 37 W m−1 K−1 in ambient air conditions. Moreover, the lowest uncertainties are obtained for thermal conductivities below 5 W m−1 K−1 typically.Keywords
This publication has 15 references indexed in Scilit:
- Calibration Tools for Scanning Thermal Microscopy Probes Used in Temperature Measurement ModeJournal of Heat Transfer, 2019
- A dark mode in scanning thermal microscopyReview of Scientific Instruments, 2017
- Scanning thermal microscopy based on a quartz tuning fork and a micro-thermocouple in active mode (2ω method)Review of Scientific Instruments, 2016
- Scanning thermal microscopy: A reviewPhysica Status Solidi (a), 2015
- Photo-thermal quartz tuning fork excitation for dynamic mode atomic force microscopeApplied Physics Letters, 2014
- Quantitative thermal microscopy using thermoelectric probe in passive modeReview of Scientific Instruments, 2013
- Two omega method for active thermocouple microscopyReview of Scientific Instruments, 2009
- Novel nanoscale thermal property imaging technique: The 2ω method. II. Demonstration and comparisonJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2006
- Novel nanoscale thermal property imaging technique: The 2ω method. I. Principle and the 2ω signal measurementJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2006
- Nanoscale heat transfer at contact between a hot tip and a substrateInternational Journal of Heat and Mass Transfer, 2006