In-situ Observation of the Environmental Resistance of Pure Iron Using Hydrogen and Oxygen Sensors in the Environment Simulating Hydrogen Combustion
Open Access
- 15 September 2024
- journal article
- research article
- Published by Iron and Steel Institute of Japan in Tetsu-to-Hagane
- Vol. 110 (12) , 932-940
Abstract
The environmental resistance of pure iron was evaluated with oxygen and hydrogen sensor installed after the oxidation furnace. The amount of introduced oxygen was precisely controlled by oxygen pump-sensor at the front stage of the oxidation furnace and the reaction with hydrogen was analyzed. As a result, when oxygen was supplied, a reaction between hydrogen and oxygen occurred, but when sufficient oxygen was not supplied, a hydrogen-vapor environment was created and oxidation was not accelerated. However, when the amount of supplied oxygen was excessive, the environment became oxygen-steam environment and the oxidation was accelerated. At that time, it was clarified that the oxidation by oxygen was dominant under the oxygen-water vapor environment, and the mass gain increased. In addition, the border of the region dominated by oxygen oxidation and that by steam oxidation was clarified by precisely controlling the amount of supplied oxygen by the oxygen pump sensor.Keywords
This publication has 23 references indexed in Scilit:
- Effect of Oxygen on Water Vapor Oxidation of Fe by Oxygen Partial Pressure Control Using Gas SensorHigh Temperature Corrosion of Materials, 2023
- Investigation of Alumina Formation and Oxidation Rate of Ni–5 wt%Al–X wt%Cr Alloy Using Hydrogen Sensor and Oxygen Pump SensorOxidation of Metals, 2020
- Investigation of High-Temperature Oxidation in Steam for Ni-Al Alloys Using the Combination of a Hydrogen Sensor and an Oxygen Pump-SensorOxidation of Metals, 2018
- The Effect of H2 and H2O on the Oxidation of 304L-Stainless Steel at 600 °C: General Behaviour (Part I)Oxidation of Metals, 2015
- Analysis of High Temperature Steam Oxidation of Superheater Steels Used in Coal Fired BoilersOxidation of Metals, 2015
- Oxidation of Binary FeCr Alloys (Fe–2.25Cr, Fe–10Cr, Fe–18Cr and Fe–25Cr) in O2 and in O2 + H2O Environment at 600 °COxidation of Metals, 2011
- Paralinear Oxidation of Chromium in O2 + H2O Environment at 600–700 °COxidation of Metals, 2008
- The Effect of Water Vapor on Selective Oxidation of Fe–Cr AlloysOxidation of Metals, 2008
- Enhanced oxidation of the 9%Cr steel P91 in water vapour containing environmentsCorrosion Science, 2006
- Anomalous temperature dependence of oxidation kinetics during steam oxidation of ferritic steels in the temperature range 550–650 °CCorrosion Science, 2004