Numerical simulation of gas-assisted injection molding using CLSVOF method
Authors:
- Qiang LiQLQiang Li
- Jie OuyangJOJie Ouyang
- Binxin YangBYBinxin Yang
- Xuejuan LiXLXuejuan Li
- 1 May 2012
- journal article
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 36 (5) , 2262-2274
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (10871159)
- National Basic Research Program of China (2005CB321704)
This publication has 27 references indexed in Scilit:
- Birefringence in gas‐assisted tubular injection moldings: Simulation and experimentPolymer Engineering & Science, 2009
- Influence of temperature and shear rate on the rheology and processability of reprocessed ABS in injection molding processJournal of Materials Processing Technology, 2009
- A coupled level set and volume-of-fluid method for sharp interface simulation of plunging breaking wavesInternational Journal of Multiphase Flow, 2009
- A volume-of-fluid method for incompressible free surface flowsInternational Journal for Numerical Methods in Fluids, 2009
- Computing three-dimensional two-phase flows with a mass-conserving level set methodComputing and Visualization in Science, 2008
- A study on gas-assisted injection molding filling simulation based on surface model of a contained circle channel partJournal of Materials Processing Technology, 2008
- Primary and secondary gas penetration during gas‐assisted injection molding. Part II: Simulation and experimentPolymer Engineering & Science, 2004
- A COUPLED LEVEL SET AND VOLUME-OF-FLUID METHOD FOR THE BUOYANCY-DRIVEN MOTION OF FLUID PARTICLESNumerical Heat Transfer, Part B: Fundamentals, 2002
- Three‐dimensional finite element solution of gas‐assisted injection mouldingInternational Journal for Numerical Methods in Engineering, 2001
- A 3‐D finite element model for gas‐assisted injection molding: Simulations and experimentsPolymer Engineering & Science, 2001