Strength-Ductility Behaviour of Al-Si-Cu-Mg Casting Alloys in T6 Temper
- 1 May 2003
- journal article
- research article
- Published by Taylor & Francis in International Journal of Cast Metals Research
- Vol. 15 (5) , 531-543
Abstract
A comparative study of the mechanical properties of 20 experimental alloys has been carried out. The effect of different contents of Si, Cu, Mg, Fe and Mn, as well as solidification rate, has been assessed using a strength-ductility chart and a quality index-strength chart developed for the alloys. The charts show that the strength generally increases and the ductility decreases with an increasing content of Cu and Mg. Increased Fe (at Fe/Mn ratio 0.5) dramatically lowers the ductility and strength of low Si alloys. Increased Si content generally increases the strength and the ductility. The increase in ductility with increased Si is particularly significant when the Fe content is high. The charts are used to show that the cracking of second phase particles imposes a limit to the maximum achievable strength by limiting the ductility of strong alloys. The (Cu + Mg) content (at.%), which determines the precipitation strengthening and the volume fraction of Cu-rich and Mg-rich intermetallics, can be used to select the alloys for given strength and ductility, provided the Fe content stays below the Si-dependent critical level for the formation of pre-eutectic α-phase particles or β-phase plates.Keywords
This publication has 41 references indexed in Scilit:
- Effect of ageing and Mg content on the quality index of two model AlCuSiMg alloysMaterials Science and Engineering: A, 1999
- The effect of strontium on the microstructure of the aluminium-silicon and aluminium-copper eutectics in the 319 aluminium alloyInternational Journal of Cast Metals Research, 1999
- Effect of Mg content on the dimensional stability and tensile properties of heat treated Al-Si-Cu (319) type alloysInternational Journal of Cast Metals Research, 1997
- Porosity formation in aluminium alloy castings under quasi-directional solidificationInternational Journal of Cast Metals Research, 1997
- Solution heat treatment of 319 aluminium alloy containing ~0.5 wt% Mg. Part 2—microstructure and fractographyInternational Journal of Cast Metals Research, 1996
- Solution heat treatment of 319 aluminium alloy containing ~0.5wt% Mg. Part 1- solidification and tensile propertiesInternational Journal of Cast Metals Research, 1996
- Porosity formation in AI-9 Wt Pct Si-3 Wt Pct Cu alloy systems: Metallographic observationsMetallurgical and Materials Transactions A, 1996
- A metallographic study of porosity and fracture behavior in relation to the tensile properties in 319.2 end chill castingsMetallurgical and Materials Transactions A, 1995
- Strontium modification of aluminium alloy castings in the expendable pattern casting processJournal of Materials Science, 1995
- Crystallization behavior of iron-containing intermetallic compounds in 319 aluminum alloyMetallurgical and Materials Transactions A, 1994