Compact Integrated Full-Duplex Gap Waveguide-Based Radio Front End For Multi-Gbit/s Point-to-Point Backhaul Links at E-Band
- 13 June 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (9) , 3783-3797
Abstract
This paper presents the design and realization of a high data rate radio front-end module for point-to-point backhaul links at E-band. The design module consists of four vertically stacked unconnected metal layers without any galvanic and electrical contact requirements among the building blocks, by using gap waveguide technology. The module components are a high-gain array antenna, diplexer, and circuitry consisting of a transmitter (Tx) and a receiver (Rx) monolithic microwave integrated circuits (MMICs) on a carrier board, which is successfully integrated into one package with a novel architecture and a compact form. The diplexer consists of two direct-coupled cavity bandpass filters with channels at 71-76 GHz and 81-86 GHz with a measured return loss of 15 dB and an isolation greater than 50 dB. A wideband $16x16$ slot array antenna with a measured gain of more than 31 dBi is used to provide high directivity. The measured results show that the packaged transmitter provides a conversion gain of 22 and 20 dB at 76 and 86 GHz, respectively, with an output power of 14 and 16 dBm at 1-dB gain compression point, at the same frequencies. The packaged receiver shows an average conversion gain of 20 dB at 71-76-GHz and 24 dB at 81-86-GHz bands. A real-time wireless data transmission is successfully demonstrated with a data rate of 8 Gbit/s using 32-quadrature amplitude modulated signal over 1.8-GHz channel bandwidth with spectral efficiency of 4.44 bit/s/Hz. The proposed radio front end provides the advantages of low loss, high efficiency, compact integration, and a simple mechanical assembly, which makes it a suitable solution for small-cell backhaul links.
Keywords
This publication has 27 references indexed in Scilit:
- An E-band antenna-diplexer compact integrated solution based on gap waveguide technology2017
- Diplexer integration into a Ka-band high-gain gap waveguide corporate-fed slot array antenna2017
- A multi-layer gap waveguide array antenna suitable for manufactured by die-sink EDM2016
- Corporate-Fed Planar 60-GHz Slot Array Made of Three Unconnected Metal Layers Using AMC Pin Surface for the Gap WaveguideIEEE Antennas and Wireless Propagation Letters, 2015
- A groove gap waveguide iris filter for V-band application2015
- Low insertion loss 61 GHz narrow-band filter implemented with Groove Gap Waveguides2014
- Design and experimental verification of ridge gap waveguide in bed of nails for parallel-plate mode suppressionIET Microwaves, Antennas & Propagation, 2011
- Measurement of the dielectric properties of Rogers R/flex 3850 liquid crystalline polymer substrate in V and W band2005
- Space mapping technique for electromagnetic optimizationIEEE Transactions on Microwave Theory and Techniques, 1994
- Artificially soft and hard surfaces in electromagneticsIEEE Transactions on Antennas and Propagation, 1990