Rotordynamics of a Highly Flexible Hub for Inside-Out Ceramic Turbine Application: Finite Element Modeling and Experimental Validation
- 29 September 2017
- journal article
- research article
- Published by ASME International in Journal of Vibration and Acoustics
- Vol. 140 (1) , 011013
Abstract
The inside-out ceramic turbine (ICT) is a promising concept to increase turbine inlet temperatures in microturbines by integrating individual monolithic ceramic. This architecture uses a carbon–polymer composite rim to support the blades mainly in compression. High tangential velocities lead to elevated radial displacement of the rim, and therefore, the rotor hub needs to have sufficient compliance to follow this radial displacement. However, the rotordynamics of a flexible hub is not widely understood. This paper presents the rotordynamic analysis of a highly flexible hub for an ICT architecture. Finite element modeling (FEM) is used to design a simplified turbine prototype that maximizes the hub flexibility to explore the limits of the concept. The rotordynamics behavior of the highly flexible hub is measured by spinning a 171-mm diameter prototype up to 49 krpm. This paper highlights three principal challenges of this particular rotordynamics. First, critical speeds mode shape becomes highly coupled with bearings displacement, shaft bending, and hub deformation. At high-speed, the hub deforms out of phase with the shaft, which can cause high stresses in the hub. Second, the angular position between unbalance masses of the flexible hub and the composite rim changes the unbalance response significantly. Finally, vibration causes high stresses in the hub, due to the relative displacement between the composite rim and the shaft, which could lead to failure of the hub. Nevertheless, the rotordynamics of an ICT configuration is manageable as long as the vibration-induced stress in the hub is kept under its limit.Keywords
This publication has 10 references indexed in Scilit:
- Development of an Inside-Out Ceramic Turbine2016
- Design and fabrication of hybrid composite hubs for a multi-rim flywheel energy storage systemComposite Structures, 2014
- Damping and Inertia Coefficients for Two Open Ends Squeeze Film Dampers With a Central Groove: Measurements and PredictionsJournal of Engineering for Gas Turbines and Power, 2012
- Slow Speed Vibration Signal Analysis: If You Can’t Do It Slow, You Can’t Do It Fast2007
- Design and Spin Test of a Hybrid Composite Flywheel Rotor with a Split Type HubJournal of Composite Materials, 2006
- The Influence of Internal Damping on the Rotordynamic Stability of a Flywheel Rotor With Flexible Hub2005
- Some Effects of Size on the Performances of Small Gas Turbines2003
- Modelling of an Elastic Disk With Finite Hub Motions and Small Elastic Vibrations With Application to RotordynamicsJournal of Vibration and Acoustics, 1996
- Development of a Set of Equations for Incorporating Disk Flexibility Effects in Rotordynamical Analyses1991
- Compression Structured Ceramic Turbine Rotor Concept1983