High-power test of a C-band linear accelerating structure with an RFSoC-based LLRF system
- 1 April 2025
- journal article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (4)
Abstract
Normal conducting linear particle accelerators consist of multiple rf stations with accelerating structure cavities. Low-level rf (LLRF) systems are employed to set the phase and amplitude of the field in the accelerating structure and to compensate for the pulse-to-pulse fluctuation of the rf field in the accelerating structures with a feedback loop. The LLRF systems are typically implemented with analog rf mixers, heterodyne-based architectures, and discrete data converters. There are multiple rf signals from each of the rf stations, so the number of rf channels required increases rapidly with multiple rf stations. With a large number of rf channels, the footprint, component cost, and system complexity of the LLRF hardware will increase significantly. To meet the design goals of being compact and affordable for future accelerators, we have designed the next-generation LLRF (NG-LLRF) with a higher integration level based on RFSoC technology. The NG-LLRF system samples rf signals directly and performs rf mixing digitally. The NG-LLRF has been characterized in loopback mode to evaluate the performance of the system and has also been tested with a standing-wave accelerating structure, a prototype for the Cool Copper Collider (C3) with a peak rf power level up to 16.45 MW. The loopback test demonstrated amplitude fluctuation below 0.15% and phase fluctuation below 0.15°, which are considerably better than the requirements of C3. The rf signals from the different stages of the accelerating structure at different power levels are measured by the NG-LLRF, which will be critical references for the control algorithm designs. The NG-LLRF also offers flexibility in waveform modulation, so we have used rf pulses with various modulation schemes, which could be useful for controlling some of the rf stations in accelerators. In this paper, the high-power test results at different stages of the test setup will be summarized, analyzed, and discussed.Keywords
Funding Information
- Office of Science (DE-AC02-76SF00515)
This publication has 10 references indexed in Scilit:
- Next Generation LLRF Control Platform for Compact C-band Linear AcceleratorEPJ Web of Conferences, 2024
- Development of RFSoC-based direct sampling highly multiplexed microwave SQUID readout for CMB and submillimeter surveys2024
- Status and future plans for C3 R&DJournal of Instrumentation, 2023
- A “Cool” route to the Higgs boson and beyond. The Cool Copper ColliderJournal of Instrumentation, 2023
- Evaluating Direct RF Sampling Performance for RFSoC-based Radio-frequency Astronomy Receivers2023
- -band two-stage rf pulse compression system with correction cavity chainPhysical Review Accelerators and Beams, 2022
- Advanced RFSoC readout for space-based superconducting sensor arrays2022
- Characterizing the performance of high-speed data converters for RFSoC-based radio astronomy receiversMonthly Notices of the Royal Astronomical Society, 2020
- Cavity voltage phase modulation to reduce the high-luminosity Large Hadron Collider rf power requirementsPhysical Review Accelerators and Beams, 2017
- RF Control Optimization and Automation for Normal Conducting Linear AcceleratorsIEEE Transactions on Nuclear Science, 2017