The object of research is the ball support system of a machine with an eccentric mass, which limits the transmission of horizontal dynamic loads to the foundation. The problem was not to transfer horizontal dynamic forces onto the foundation‚ thus stabilizing the machine without an increase in the structural mass of the equipment and guaranteeing adaptation to varying operating conditions․ For the analysis of the support design efficiency, a mathematical model of the restoring force depending on the weight of the machine, geometrical parameters of the support, and allowable displacement of the machine body was created. On the basis of this model, the nonlinear dependency of the restoring force and its linear approximation were obtained. Further analysis of their properties was conducted numerically by using the technical parameters of the KKD-1500/180 cone crusher. The investigation results indicate that the force which acts to restore depends only on the load caused by the weight of the machinery and the geometry of the spherical surface contacts. With the geometric coefficient of k = 1–1.5, the system has self-limited behavior in relation to the vibration amplitude of the machinery body. The analysis of the differences between the absolute values of the restoring forces obtained by both models and the relative error of the linearization demonstrated that, at low displacements δ ≤ 40 mm, the linearization error is less than 0.88%. Intermediate displacements δ = 40–80 mm and critical displacement δ = 150 mm have errors equal to 4.7% and 32%, respectively. In the last case, the linearization results in lower values of the restoring force. Thus, these relationships can be employed in the development of ball support systems that have spherical contact surfaces of machines that possess eccentric masses experiencing considerable horizontal dynamic load. When carrying out preliminary designs and during normal working conditions (δ ≤ 40 mm), the linear approximation may be regarded as sufficiently accurate. However, operating conditions close to resonance, resonance passage, and those concerning transient and emergency loads for displacements δ > 80 mm require the application of the nonlinear model.