Ray-Tracing-Based Modeling and Experimental Validation of Irradiance Fields in Xenon Flashlamp Heating Systems with Quartz Light Guides
Authors:
- Juan RuizJRJuan Ruiz
- Mark SmeetsMSMark Smeets
- Paul DavidsonPDPaul Davidson
Preprint
- 21 February 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Flashlamp-based heating enables millisecond-scale thermal processing for manufacturing applications such as annealing and in-situ consolidation of composite parts, but the large parameter space of lamp operation and optical delivery hardware often necessitates extensive trial-and-error tuning. This work develops and validates a ray-tracing-based optical model of a xenon arc flashlamp, both with and without a three-faceted fused-silica light guide, to predict spatially resolved irradiance fields for process modeling. Full-field irradiance measurements were acquired using a water-cooled Gardon gauge mounted on a six-axis robotic arm, producing dense irradiance maps around the bare lamp and the lamp–guide assembly. The optical model was implemented in TracePro using measured spectral emission data and a calibrated angular radiation pattern, with lamp housing reflections represented by an idealized high-reflectivity surface. A parametric calibration study identified an 18 mm diameter cylindrical emitter as the best single-source approximation. To better capture the experimentally observed central irradiance enhancement, a two-source representation was introduced by augmenting the cylindrical emitter with a secondary planar emitter, yielding modest improvements in agreement with measurements across multiple planes (RMSE as low as ∼ 0.007 for lamp-only profiles). For the lamp with the three-faceted quartz guide, the model reproduced key irradiance features near the top facet, including peak magnitudes of 0.26– 0.27 MW/m2, with localized discrepancies attributed primarily to measurement resolution near sharp geometric transitions. Finally, a sensitivity study on the guide taper angle (0◦–7◦) revealed a trade-off between irradiance intensification at the top facet and side-facet leakage, with maximum irradiance of 0.485 MW/m2 at a 4◦ taper and an application-relevant design range of approximately 3◦–6◦. The validated modeling framework provides a pathway for predicting delivered irradiance in flashlamp-based manufacturing and for guiding optical design toward reduced empirical tuning.Keywords
This publication has 8 references indexed in Scilit:
- A snapshot review on flash lamp annealing of semiconductor materialsMRS Advances, 2022
- Artificial neural network-based modeling of flashlamp characteristicsElectrical Engineering, 2022
- Heat transfer modelling of flashlamp heating for automated tape placement of thermoplastic compositesComposites Part A: Applied Science and Manufacturing, 2021
- Optical constants of silica glass from extreme ultraviolet to far infrared at near room temperatureApplied Optics, 2007
- Xenon Flash Lamp Annealing of Poly-Si Thin FilmsJournal of the Electrochemical Society, 2006
- Wavelength-dependent model of Kr flash lamp emission and absorption.Applied Optics, 1997
- Flashlamp pumping of Nd:glass disk amplifiers1990
- Analysis of thermal stresses induced in silicon during xenon arc lamp flash annealingJournal of Applied Physics, 1983