Numerical evaluation of wall-guided spark assistance for cold operations in a heavy-duty gasoline compression ignition engine
- 25 October 2025
- journal article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 27 (4) , 587-603
Abstract
This study focused on conducting three-dimensional (3D) computational fluid dynamics (CFD) simulations to evaluate the impact of wall-guided spark plug ignition assistance on gasoline compression ignition (GCI) combustion performance during cold operations. The numerical simulations were performed on a 6-cylinder, 15 L heavy-duty diesel engine operating at a compression ratio (CR) of 16.5 using RON92 E0 gasoline. Spark assistance was simulated by incorporating an ignition model with the necessary spark energy to ensure stable combustion during cold operations. Initially, closed-cycle 3D CFD combustion simulations, based on a design of experiments (DoE) campaign, were employed to investigate a lean spark-assisted CI strategy during the cold-to-warm transition. A numerical optimization approach, based on a Response Surface Model (RSM), was adopted to optimize injector spray patterns, fuel injection strategies, and in-cylinder swirl motion to achieve the best performance of wall-guided spark assistance combustion. The optimized injector spray pattern, fuel injection strategy, and swirl ratio were predicted to provide 12 percentage points increase in combustion efficiency over the baseline, while meeting constraints for maximum pressure rise rate (MPRR) and NO x emissions (MPRR < 5 bar/CAD and NO x < 2 g/kWh). Building on the aforementioned optimal design, an open-cycle 3D CFD analysis was subsequently carried out to simulate engine starts at various cold ambient temperatures using a stoichiometric, spark-initiated flame propagation strategy. The results showed that with the optimized design, reasonable GCI combustion during engine starts was achieved at cold ambient temperature of 300 K. Notably, as the ambient temperature decreases from 300 to 243 K, the emergence of a noticeable fuel film was observed, presenting an undesirable potential for increased engine-out unburned hydrocarbon and smoke emissions. Considering the specific emission requirements at lower ambient temperatures, further investigations are warranted to assess the significance of the observed fuel film in relation to these criteria.Keywords
This publication has 37 references indexed in Scilit:
- Tribological investigation of the new combustion chamber with wall-guided fuel injection in a diesel engineInternational Journal of Engine Research, 2024
- Computational fluid dynamics–guided engine combustion system design optimization using design of experiments2022
- Numerical Evaluation of Spray-Guided Glow Plug Assistance on Gasoline Compression Ignition During Cold Idle Operation in a Heavy-Duty Diesel Engine2020
- The initiation and development of combustion under cold idling conditions using a glow plug in diesel enginesInternational Journal of Engine Research, 2016
- An Evaluation of Combustion and Emissions Performance With Low Cetane Naphtha Fuels in a Multicylinder Heavy-Duty Diesel EngineJournal of Engineering for Gas Turbines and Power, 2016
- Review of high efficiency and clean reactivity controlled compression ignition (RCCI) combustion in internal combustion enginesProgress in Energy and Combustion Science, 2015
- Enhancement on a Skeletal Kinetic Model for Primary Reference Fuel Oxidation by Using a Semidecoupling MethodologyEnergy & Fuels, 2012
- Low NOx and Low Smoke Operation of a Diesel Engine Using Gasolinelike FuelsJournal of Engineering for Gas Turbines and Power, 2010
- HCCI experiments with toluene reference fuels modeled by a semidetailed chemical kinetic modelCombustion and Flame, 2008
- A New Droplet Collision AlgorithmJournal of Computational Physics, 2000