An Inertial Uni-Axial Interferometer-Based Accelerometer for Harsh Environments
Open Access
- 4 October 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (22) , 21540-21549
Abstract
For high-impact devices, subsequent vibrations have as much influence on the deterioration of the mechanical structure as the impact itself. To mitigate the consequences of both impacts and resulting vibrations, it is crucial to accurately understand the peak acceleration and vibration frequencies that originate in the structure. In this article, a radiation tolerant opto-mechanical sensor based on an absolute measurement inertial accelerometer is presented. This method of measurement is chosen due to the viability of placing the readout electronics far from the highly radioactive environment that the sensor may be installed in. The designed accelerometer consists of a fixed aluminum frame with a built-in membrane that acts as a leaf spring. In the same membrane, a retro-reflector is attached which acts as a seismic mass. The retro-reflector reflects the light beam coming from the collimator lens placed on the frame. To prove its viability, the device has been tested under different conditions. First, the device is calibrated and validated using a high-frequency exciter. Second, a high-acceleration testbench is used to compare its output signal with a commercial accelerometer and verify its proper operation as well as its expected lifetime. The experimental results showed an average sensitivity of ${9} \times {10}^{-{4}}$ g/pm with reading measurements of up to 5000 g and a working bandwidth located between 50 and 800 Hz.Keywords
Funding Information
- Mechatronics, Robotics and Operations Section (BE-CEM-MRO), European Organization for Nuclear Research
This publication has 16 references indexed in Scilit:
- Theoretical Analysis of an Optical Accelerometer Based on Resonant Optical Tunneling EffectSensors, 2017
- Prototype of interferometric absolute motion sensorSensors and Actuators A: Physical, 2015
- Review: Inertial Sensors for Low-Frequency Seismic Vibration MeasurementBulletin of the Seismological Society of America, 2012
- Tunable mechanical monolithic sensor with interferometric readout for low frequency seismic noise measurementNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2010
- Fiber-laser-based wavelength-division multiplexed fiber Bragg grating sensor systemIEEE Photonics Technology Letters, 2001
- Opto-mechanical accelerometer based on strain sensing by a Bragg grating in a planar waveguideSensors and Actuators A: Physical, 1996
- Highly sensitive wideband seismometer using a laser interferometerReview of Scientific Instruments, 1993
- A fiber-optic interferometric seismometerJournal of Lightwave Technology, 1987
- Design of feedback-controlled wide-band seismographs with respect to undesired side-effectsPhysics of the Earth and Planetary Interiors, 1979
- Wide-band feedback seismometersPhysics of the Earth and Planetary Interiors, 1979