Thermal Conductivity of Liquid trans-1,2-Dichloroethene (R-1130(E)): Measurement and Modeling
Open Access
- 12 February 2024
- journal article
- research article
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 45 (3) , 1-16
Abstract
The thermal conductivity of liquid trans-1,2-dichloroethene (R-1130(E)) was measured at temperatures ranging from 240 K to 340 K and pressures up to 25 MPa using a transient hot-wire instrument. A total of 447 thermal conductivity data points were measured along six isotherms. Each isotherm includes data at nine pressures, which were chosen to be at equal density increments starting at a pressure of 0.1 MPa (or slightly above the saturation pressure of R-1130(E) at temperatures above its normal boiling point) to a maximum pressure of 25 MPa. The combined expanded uncertainty of the presented experimental data is 1.4% at a 95% confidence level. The experimental data were used to evaluate the performance of an extended corresponding states (ECS) model and a residual entropy scaling (RES) model. Both models were applied in a totally predictive mode, and in a mode where the experimental data were used to tune the model parameters. A volume-translated Peng–Robinson equation of state was used to provide thermodynamic properties needed to apply both models. In a totally predictive mode, the ECS model had an average absolute relative deviation (ΔAARD) of 6.89% relative to the experimental data with the largest deviation being − 8.33%. The RES model in a totally predictive mode showed an ΔAARD of 2.55% with the largest deviation being − 5.81%. When model parameters were fitted to the experimental data, both the ECS and the RES model represented the experimental data to within its uncertainty of 1.4%.Keywords
This publication has 41 references indexed in Scilit:
- An International Standard Formulation for 2,3,3,3-Tetrafluoroprop-1-ene (R1234yf) Covering Temperatures from the Triple Point Temperature to 410 K and Pressures Up to 100 MPaInternational Journal of Thermophysics, 2022
- Vapor Pressure, $(p, \rho , T)$ Behavior, Saturated Densities, and Surface Tension of trans-1,2-Dichloroethene [R1130(E)]International Journal of Thermophysics, 2022
- European emissions of the powerful greenhouse gases hydrofluorocarbons inferred from atmospheric measurements and their comparison with annual national reports to UNFCCCAtmospheric Environment, 2017
- Simplified Model for the Critical Thermal-Conductivity Enhancement in Molecular FluidsInternational Journal of Thermophysics, 2013
- Densities and excess molar volumes for binary mixtures containing 2,2,4-trimethylpentane and six different chlorohydrocarbons at 298.15 KThermochimica Acta, 1994
- A simplified representation for the thermal conductivity of fluids in the critical regionInternational Journal of Thermophysics, 1989
- A consistent correction for Redlich-Kwong-Soave volumesFluid Phase Equilibria, 1982
- The Thermal Conductivity of Water to 250°C and 350 MPaBerichte der Bunsengesellschaft für physikalische Chemie, 1981
- The theory of the transient hot-wire method for measuring thermal conductivityPhysica B+C, 1976
- Viscosities of cis‐ and trans‐ 1‐2‐dichloroethene, in connection with Eyring's theory of viscous flowRecueil des Travaux Chimiques des Pays-Bas, 1947