The effect of process parameters and cutting tool shape on residual stress of SAE 52100 hard turned steel by high speed machining
- 25 June 2020
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 235 (1-2) , 290-300
Abstract
This study focused on determining the residual stress of SAE 52100 hard-turned steel. The objective was to evaluate and compare the effects of the cutting-edge geometry and cutting parameters (cutting speed, feed rate, and cutting depth) on the residual stresses of three different conventional inserts: S-WNGA08 0408S01020A 7025, T-WNGA08 0408T01020A 7025, and S-WNGA432S0330A 7025. Tests were performed on 60 samples of SAE 52100 hardened steel with an average hardness of 58.5 HRC. The circumferential residual stresses of the samples were measured by X-ray diffraction. A full factorial design of experiments with three factors and two levels each with two central points and a replicate was used for a statistical analysis. The most significant results were as follows: For all inserts, the measured residual stresses were compressive, which extended the tool lifespan. The residual stresses of the Type-S inserts were significantly influenced by the cutting speed and depth, and those of the Type-T insert were significantly influenced by the feed rate and cutting depth. In addition, the residual stresses of the insert 3 were more compressive than those of the other two types of inserts. In other words, residual stresses are more compressive for inserts with larger chamfer angles even as the principal residual stress profiles were all compressive. This work has also shown that it is possible to determine a significant statistical relationship between cutting forces and residual stresses, allowing force measurements to predict the residual stress without any information on process parameters.Keywords
This publication has 45 references indexed in Scilit:
- Investigation of surface damage and roughness for nickel-based superalloy GH4169 under hard turning processingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2019
- Experimental study on the chip morphology, tool–chip contact length, workpiece vibration, and surface roughness during high-speed face milling of A6061 aluminum alloyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2019
- Surface integrity in broaching of AA 7075-T651 aluminum alloysMachining Science and Technology, 2018
- Stable cutting zone prediction in CNC turning using adaptive signal processing technique merged with artificial neural network and multi-objective genetic algorithmEuropean Journal of Mechanics - A/Solids, 2018
- Experimental Analysis and Investigation of Machining Parameters in Finish Hard Turning of AISI 4340 SteelProcedia Manufacturing, 2018
- Modelling of Flank wear, Surface roughness and Cutting Temperature in Sustainable Hard Turning of AISI D2 SteelProcedia Manufacturing, 2018
- Surface integrity in cryogenic machining of nickel based alloy—Inconel 718Journal of Materials Processing Technology, 2011
- Residual stress and surface roughness when facing age hardened Inconel 718 with CBN and ceramic cutting toolsInternational Journal of Machine Tools and Manufacture, 2004
- Wear behavior of CBN tools while turning various hardened steelsWear, 2004
- Heat-Affected Zones in Grinding SteelCIRP Annals, 1994