Effect of machining parameters on the machinability of 15‐5 precipitation hardened stainless steel during dry turning
- 28 January 2025
- journal article
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 56 (2) , 281-289
Abstract
This research presents the studies on the effect of machining variables and the empirical modeling of machinability output responses during dry turning of 15–5 precipitation‐hardened stainless steel (PHSS) using the taguchi meta‐heuristic algorithm. L9 orthogonal array (OA) robust experimental design was selected for conducting the dry turning operations. The input variables included cutting velocity, depth of cut, and feed rate, while the output responses measured were surface roughness (Ra) and cutting force (Fc). The influence of these process variables was determined through analysis of variance (ANOVA). ANOVA results revealed that cutting speed, feed rate and depth of cut were impacting the average surface roughness by 36 %, 29 %, and 31 %, respectively and influencing the cutting force by 2 %, 16 %, and 72 %, respectively, during turning operation. Empirical models for predicting cutting force and surface roughness were developed using the Taguchi meta‐heuristic algorithm. The optimization process resulted in a significant reduction in surface roughness, with Ra decreasing by 17 % and a notable decrease in cutting force, Fc, by 8 %. These numerical improvements indicate that the proposed optimization approach substantially enhances machining performance, validating its effectiveness.Keywords
This publication has 15 references indexed in Scilit:
- Fabrication of wear resistant nanocomposite and its mechanical properties: A step towards sustainabilityMaterialwissenschaft und Werkstofftechnik, 2024
- An appropriate approach of design and machining of mechanical part by means of probabilistic multi‐objective optimizationMaterialwissenschaft und Werkstofftechnik, 2024
- Empirical modeling of profile roughness parameters during end milling of aluminium alloy 5052/tungsten carbide/graphite hybrid compositeMaterialwissenschaft und Werkstofftechnik, 2023
- Performance Evaluation of Textured Inserts with MQL in Machining of PH Stainless SteelMaterials Today: Proceedings, 2021
- Experimental investigation and sustainability assessment to evaluate environmentally clean machining of 15-5 PH stainless steelJournal of Manufacturing Processes, 2020
- Experimental investigation and modelling of MQL assisted turning process during machining of 15-5 PH stainless steel using response surface methodologySN Applied Sciences, 2019
- Modeling and optimization of sustainable manufacturing process in machining of 17-4 PH stainless steelMeasurement, 2019
- Effect of cryogenic coolant on turning performance characteristics during machining of 17-4 PH stainless steel: A comparison with MQL, wet, dry machiningCIRP Journal of Manufacturing Science and Technology, 2018
- A comparative study on machinability of cryo-treated and peak aged 15Cr-5Ni precipitation hardened stainless steelMeasurement, 2018
- The effect of aging on machinability of 15Cr–5Ni precipitation hardened stainless steelArchives of Civil and Mechanical Engineering, 2016