Experimental study of boundary conditions on the perforated walls of test sections no. 1 and 2 of T-128 transonic wind tunnel
Open Access
- 2 November 2018
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2027 (1) , 040025
Abstract
This study outlines the results of experimental research on flow parameters (flow angularity and static pressure) near a perforated wall using a six-hole probe located on the wall of T-128 wind tunnel test section in the area of significant perturbation caused by the model. In test section 1 the probe was set on the upper and lower walls (during the tests of a full-scale model); in test section 2 – on the side wall (during the tests of a half model). The perforation ratio varied from f=2% to f=10%. The distance between the perforated wall and the probe varied from 70 mm to 200 mm in order to detect the position where the probe is above the boundary layer. Technique to process acquired experimental data and to determine porosity coefficient R was developed and described in detail. A particular care was taken to study perforation f=6% since it is considered as an optimality state in terms of minimizing flow boundary interference in subsonic tests. All the measurements were made during industrial tests of various models in a wide range of subsonic speeds 0.2≤М≤0.95. The introduction includes the review of works on the topic. The study provides examples of flow computation near perforated walls of wind tunnel test section for the tests of flight vehicle models using acquired boundary condition parameters.This publication has 13 references indexed in Scilit:
- Pioneering Russian wind tunnels and first experimental investigations, 1871–1915Progress in Aerospace Sciences, 2017
- Influence of movable test section elements configuration on its drag and flow field uniformity at transonic speedsAIP Conference Proceedings, 2016
- Numerical simulation of flows around deformed aircraft model in a wind tunnelAIP Conference Proceedings, 2016
- Numerical Analysis of Flow through a Hole for Modeling of Wind Tunnel Porous WallTRANSACTIONS OF THE JAPAN SOCIETY FOR AERONAUTICAL AND SPACE SCIENCES, 2011
- Recent experience in improving the accuracy of wall interference corrections in TsAGI T-128 wind tunnelProgress in Aerospace Sciences, 2001
- Tunnel interference assessment by boundary measurementsAIAA Journal, 1978
- Sparsity, by A. Brameller, R. N. Allan and Y. M. Hamam. Pp 177. £7. 1976. SBN 0 273 00938 9 (Pitman)The Mathematical Gazette, 1977
- NEWS FOCUSChemical & Engineering News, 1969
- The K-Product of Arithmetic FunctionsCanadian Journal of Mathematics, 1965
- Decrees of a Meath Diocesan Synod, 1686Archivium Hibernicum, 1957