Design of a 3D Top-Loaded Low-Profile Sleeve Antenna for UAV Applications
Open Access
- 30 March 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 64718-64724
Abstract
In this article, a 3D top-loaded low profile sleeve antenna for unmanned aerial vehicle (UAV) applications is proposed. By loading a 3D disc cone structure on the top of a sleeve antenna, the overall height of the antenna can be significantly reduced compared with the height of a traditional quarter-wavelength monopole antenna. In addition, adding shorted columns between the top plate of the disc cone and the ground can generate a new resonant point at lower frequency, so that the frequency bandwidth can be effectively extended. Finally, in order to further achieve the miniaturization of the antenna, an annular slot ring structure was etched on the upper surface of the top plate. Under the conditions of S11 <-10dB, the designed antenna with a total size of 160mm × 160mm × 26.6mm ( 0.44λ×0.44λ×0.07λ ) has a wide band covering from 840MHz to 1.69GHz (67.2%), while the height of the proposed antenna is only 0.07λ (where λ is the wavelength of the lowest frequency point). Moreover, omnidirectional radiation performances through the operating band can be achieved for both the measured and simulated results.Keywords
Funding Information
- Special Funds for Basic Scientific Research of Southeast University (2242019K40267)
- Priority Academic Program Development of Jiangsu Higher Education Institutions
- Kunshan & Nanjing University of Information Science and Technology (NUIST) Intelligent Sensor Research Center Project
This publication has 16 references indexed in Scilit:
- Three‐dimensional‐printed tapered cavity‐backed flush‐mountable wideband antenna for UAVMicrowave and Optical Technology Letters, 2017
- Compact and Low-Profile Omnidirectional Circularly Polarized Antenna With Four Coupling Arcs for UAV ApplicationsIEEE Antennas and Wireless Propagation Letters, 2017
- Ultra-wide band antenna attachable on UAV surfaceInternational Journal of RF and Microwave Computer-Aided Engineering, 2017
- Experimental Investigations of a Novel Lightweight Blade Antenna for UAV Applications [Antenna Applications Corner]IEEE Antennas and Propagation Magazine, 2017
- A flush‐mounted monopolar patch antenna for UAV applicationsMicrowave and Optical Technology Letters, 2017
- Wideband low‐profile planar square segmented loop antenna for UAV applicationsElectronics Letters, 2016
- Low‐profile omnidirectional antenna for automatic dependent surveillance – broadcast applicationsElectronics Letters, 2015
- Bifilar Helix GNSS Antenna for Unmanned Aerial Vehicle ApplicationsIEEE Antennas and Wireless Propagation Letters, 2014
- Dual-Polarized Hexaferrite Antenna for Unmanned Aerial Vehicle (UAV) ApplicationsIEEE Antennas and Wireless Propagation Letters, 2013
- Low-profile and horizontally-polarised antenna for UAV applicationsElectronics Letters, 2009