A Highly Reliable SIMO Converter Using Hybrid Starter and Overcharging Protector for Energy Harvesting Systems
Open Access
- 2 September 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 162172-162179
Abstract
This paper proposes a highly reliable single-inductor multi-output (SIMO) converter for energy harvesting systems, which is controlled by the power management controller (PMC) including the hybrid starter, overcharging protector (OCP), and switch controller (SWC). The proposed hybrid starter employs the power-on-reset to accurately control the activated and deactivated moments of the SWC, thus generating a system supply voltage (VSYS) within the stable operating voltage range. The proposed OCP employs the diode-connection and Schmitt trigger schemes to monitor the voltage of a storage device (VSTG) in real time, thereby protecting the IC from being damaged without using either a capacitor or Zener diode, which causes the additional area or reverse leakage current, respectively. The proposed SIMO converter with the PMC was fabricated using 0.18-μm CMOS process. The measurement results show that VSYS values at the activated and deactivated moments of the SWC are 1.798 V and 1.510 V, respectively, both of which are within the stable system voltage range for 1.8 V devices. In addition, the measured maximum VSTG is 5.892 V, which is much lower than an absolute maximum rated voltage of 9.2 V for 5 V devices. Furthermore, the measurement results reveal that the hybrid starter allows the proposed SIMO converter to be properly restarted immediately after VSYS is shorted to ground, while the OCP safely protects the SIMO converter even when the storage device is removed from the IC while charging. Therefore, the proposed SIMO converter with the PMC is suitable for energy harvesting systems that require high reliability.Keywords
This publication has 12 references indexed in Scilit:
- A Reconfigurable and Extendable Single-Inductor Single-Path Three-Switch Converter for Indoor Photovoltaic Energy HarvestingIEEE Journal of Solid-State Circuits, 2020
- A High Peak Output Power and High Power Conversion Efficiency SIMIMO Converter Using Optimal on-Time Control and Hybrid Zero Current Switching for Energy Harvesting Systems in IoT ApplicationsIEEE Transactions on Power Electronics, 2020
- MISIMO: A Multi-Input Single-Inductor Multi-Output Energy Harvesting Platform in 28-nm FDSOI for Powering Net-Zero-Energy SystemsIEEE Journal of Solid-State Circuits, 2018
- A 50 nW-to-10 mW Output Power Tri-Mode Digital Buck Converter With Self-Tracking Zero Current Detection for Photovoltaic Energy HarvestingIEEE Journal of Solid-State Circuits, 2016
- A 400 nW Single-Inductor Dual-Input–Tri-Output DC–DC Buck–Boost Converter With Maximum Power Point Tracking for Indoor Photovoltaic Energy HarvestingIEEE Journal of Solid-State Circuits, 2015
- A Single-Inductor 0.35 µm CMOS Energy-Investing Piezoelectric HarvesterIEEE Journal of Solid-State Circuits, 2014
- Platform Architecture for Solar, Thermal, and Vibration Energy Combining With MPPT and Single InductorIEEE Journal of Solid-State Circuits, 2012
- Startup Techniques for 95 mV Step-Up Converter by Capacitor Pass-On Scheme and ${\rm V}_{\rm TH}$-Tuned Oscillator With Fixed Charge ProgrammingIEEE Journal of Solid-State Circuits, 2012
- A Battery-Less Thermoelectric Energy Harvesting Interface Circuit With 35 mV Startup VoltageIEEE Journal of Solid-State Circuits, 2010
- RF energy harvesting system and circuits for charging of mobile devicesIEEE Transactions on Consumer Electronics, 2010