Finite element study on three osteotomy methods for treating thoracolumbar osteoporotic fracture vertebral collapse complicated with neurological dysfunction
Open Access
- 16 February 2024
- journal article
- research article
- Published by Wolters Kluwer Health in Medicine
- Vol. 103 (7) , e36987
Abstract
Background: Surgical methods for patients with osteoporotic fracture vertebral collapse complicated with neurological dysfunction are still a topic of debate. We designed an improved osteotomy for the treatment of osteoporotic compression fracture patients with neurological dysfunction. Compared with traditional osteotomy methods such as pedicle subtraction osteotomy (PSO) and bone-disc-bone osteotomy (BDBO), the osteotomy range is reduced. Therefore, we use a finite element method to analyze the biomechanical conditions of these three osteotomy methods and provide a mechanical theoretical basis for the surgical treatment of these three osteotomy methods. Methods: Based on the CT scan of a patient with L1 osteoporotic fracture vertebral collapse and neurological dysfunction, the finite element model was constructed by importing Mimics software, and three different osteotomy models were established. The forces and displacements of internal fixation device, T1-L5 whole segment, T10 vertebral body, and T10/11 intervertebral disc were recorded under different working conditions. Results: The displacement levels of internal fixation device, T1-L5 spine, T10 vertebral body, and T10/11 intervertebral disc in the modified osteotomy group were between BDBO group and PSO group. The stress in BDBO group was concentrated in titanium mesh and its maximum stress was much higher than that in PSO group and modified osteotomy group. The mechanical distribution of T10/11 intervertebral disc showed that the maximum stress distribution of the three osteotomy methods was similar. Conclusion: The relatively simple modified osteotomy has certain advantages in stress and displacement. In contrast, the stability of BDBO group was poor, especially in the lumbar intervertebral disc and lumbar body. For this type of osteotomy patients, it is recommended to avoid postoperative flexion so as not to increase the load.Keywords
This publication has 25 references indexed in Scilit:
- Optimizing bone cement stiffness for vertebroplasty through biomechanical effects analysis based on patient-specific three-dimensional finite element modelingMedical & Biological Engineering & Computing, 2018
- Spatiotemporal characterization of microdamage accumulation in rat ulnae in response to uniaxial compressive fatigue loadingBone, 2018
- Comparison of the Pullout Strength of Different Pedicle Screw Designs and Augmentation Techniques in an Osteoporotic Bone ModelAsian Spine Journal, 2018
- Biomechanical comparison of pedicle screw augmented with different volumes of polymethylmethacrylate in osteoporotic and severely osteoporotic cadaveric lumbar vertebrae: an experimental studyThe Spine Journal, 2016
- An Effective Treatment Option for Kümmell Disease With Neurological DeficitsSpine, 2016
- Biomechanical characteristics of pedicle screws in osteoporotic vertebrae—comparing a new cadaver corpectomy model and pure pull‐out testingJournal of Orthopaedic Research, 2016
- The Biomechanical Properties of Pedicle Screw Fixation Combined With Trajectory Bone Cement Augmentation in Osteoporotic VertebraeClinical Spine Surgery, 2016
- A New Method for Calculating the Exact Angle Required for Spinal OsteotomySpine, 2013
- Enhancing Pedicle Screw Fixation in the Aging Spine With a Novel Bioactive Bone CementSpine, 2012
- Posterior Correction and Fixation Without Anterior Fusion for Pseudoarthrosis With Kyphotic Deformity in Ankylosing SpondylitisSpine, 2006