Development of a 3D-Printed Two-Stage Virtual Impactor for Radioactive Aerosol Size Classification and Direct Analysis
Open Access
- 19 July 2026
- journal article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (30) , 45423-45438
Abstract
Radioactive aerosol size classification is important for exposure assessment and decommissioning operations, particularly at the Fukushima Daiichi Nuclear Power Plant decommissioning site, where airborne particles may be generated or resuspended during remote inspection and debris retrieval. This study presents the development of a two-stage 3D-printed virtual impactor, called μSPLIT, designed to separate aerosols into three aerodynamic diameter classes (>10 μm, 1–10 μm, and <1 μm) while enabling direct postcollection analysis on integrated filters. The objective is to develop a virtual impactor that can be fabricated at a reduced cost and be disposed of easily after usage by incineration, without generating any hazardous human exposure during cleaning and decontamination activities, and free from metallic wastes that are not easily disposed of. The flow path was designed and optimized by computational fluid dynamics and Lagrangian particle tracking, and prototypes were fabricated by stereolithography. Numerical simulations predicted cutoff diameters of 9.0 and 1.3 μm for the first and second stages, respectively, with relatively sharp separation in both cases. The simulations also identified limitations of the current geometry, including small-particle contamination in the minor flow and large-particle contamination in the major flow of the second stage. Dimensional measurements of printed prototypes revealed contraction and corner rounding in the internal channels, confirming the need for fabrication compensation and quality control. Experimental tests with incense smoke provided a preliminary functional check, showing that submicrometric particles were mostly collected in the <1 μm particle class. Additional tests with Rn-progeny-bearing NaCl particles, characterized by a geometric mean aerodynamic diameter of 1.70 μm, produced the highest α activity on the middle filter (1–10 μm particle class), consistent with the expected classification. These results demonstrate the proof of concept of a lightweight and low-cost impactor for simultaneous aerosol size classification and direct radioactive particle analysis, while also identifying key areas requiring further optimization, particularly the second-stage geometry, quantitative wall loss assessment, and validation with standardized aerosols.Keywords
Funding Information
- Japan Society for the Promotion of Science (24K08314)
This publication has 22 references indexed in Scilit:
- Optimization of nozzle geometry for virtual impaction across more than one decade in particle sizeJournal of Aerosol Science, 2024
- Development of an in-situ continuous air monitor for the measurement of highly radioactive alpha-emitting particulates (-aerosols) under high humidity environmentNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2022
- Analysis on the bias of the PM2.5 separator for polydispersed aerosol size distributionSeparation and Purification Technology, 2013
- The formation of incense smokeJournal of Aerosol Science, 2007
- Particle size distribution and PAH concentrations of incense smoke in a combustion chamberEnvironmental Pollution, 2007
- EFFECT OF PARTICLE SIZE AND MATERIAL PROPERTIES ON AERODYNAMIC RESUSPENSION FROM SURFACESJournal of Aerosol Science, 2000
- On predicting particle-laden turbulent flowsFlow, Turbulence and Combustion, 1994
- Classification performance of a rectangular jet virtual impactor—effect of nozzle width ratio of collection nozzle to acceleration jetJournal of Aerosol Science, 1988
- An improved virtual impactor: Design and performanceJournal of Aerosol Science, 1987
- Size classification of industrial sub-micron powder by a virtual impactorPowder Technology, 1987