Contact Load on the Current-Carrying Tribological Performance of Copper–Graphite Composites
Open Access
Abstract
This study investigates the current-carrying tribological properties and wear mechanisms of copper–graphite composites under varying contact loads. Two copper–graphite composites with different graphite content were prepared using the pressure sintering method. Current-carrying tribological tests were conducted at three distinct contact loads. Scanning electron microscopy, X-ray diffraction, laser confocal microscopy, and pin-on-disk tribological testing were utilized to examine the current-carrying tribological properties and the worn morphologies of the materials. The results indicate that, under the three contact loads, the friction coefficient of the copper–graphite materials ranged from 0.3 to 0.5, the wear rate was on the order of 10−13 m3/(N·m), the average voltage drop varied between 0.7 and 1.6 V, and the average electrical noise ranged from 0.2 to 0.9 mV. The wear mechanism included delamination wear and a minor amount of abrasive wear, and the lubricating film formed on the surface was mainly composed of C, PbO, and CuO. Notably, copper–graphite composites with lower graphite content exhibited superior hardness, electrical conductivity, and relative density compared to those with higher graphite content. At a contact load of 0.31 N, the copper–graphite composite containing 30wt% graphite demonstrated the most favorable current-carrying tribological performance, characterized by the lowest wear rate (1.09 × 10−13 m3/(N·m)), voltage drop (0.943 V), and electrical noise (0.234 mV).Keywords
Funding Information
- Major Science and Technology Projects of Jiangxi Province (20223AAE01002, 20243BCE51035, 20243BCE51183)
- Gan-Po Talent Support Program of Jiangxi Province (20223AAE01002, 20243BCE51035, 20243BCE51183)
This publication has 46 references indexed in Scilit:
- Effect of Bimodal Structure on the Frictional Properties of Copper–Graphite CompositesTransactions of the Indian Institute of Metals, 2023
- Heat conduction and thermal expansion of copper–graphite composite as a heat sinkInternational Journal of Energy Research, 2022
- Influence of contact parameters on the coupling temperature of copper-brass electrical contactsEngineering Failure Analysis, 2022
- Microstructure, and Physical and Mechanical Properties of Copper–Graphite Composites Obtained by In Situ Reaction MethodJournal of Materials Engineering and Performance, 2020
- Low-Pressure Cold Spraying of Copper–Graphite Solid Lubricating Coatings on Aluminum Alloy 7075-T651Journal of Thermal Spray Technology, 2019
- The Effect of Sintering Temperature on the Microstructures and Properties of Resin-Bonded Copper–Graphite Brush MaterialsTribology Letters, 2019
- Influence of Wear Test Parameters on the Electrical Contact Performance of Brass Alloy/Copper Contactors Under Fretting WearJournal of Materials Engineering and Performance, 2019
- Novel Design of Copper–Graphite Self-Lubricating Composites for Reliability Improvement Based on 3D Network Structures of Copper MatrixTribology Letters, 2018
- Copper–graphite composites: thermal expansion, thermal and electrical conductivities, and cross-property connectionsJournal of Materials Science, 2016
- Tribological Properties and Electrical Signal Transmission of Copper–Graphite CompositesTribology Letters, 2007