A Millimeter-Wave Receiver Using a Wideband Low-Noise Amplifier With One-Port Coupled Resonator Loads
- 22 April 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 68 (9) , 3794-3803
Abstract
This article presents design techniques to facilitate the use of the driving point impedance (Z₁₁) of one-port transformer-coupled resonators as wideband loads of millimeter-wave amplifier stages for a 28-GHz receiver front end. While the use of both the Z₁₁ of a one-port and the transimpedance (Z₂₁) of a two-port coupled resonator is considered to achieve a wideband response, it is shown that under conditions of low magnetic coupling and constrained network quality factor, the use of Z₁₁ can result in a higher gain-bandwidth product of low-noise amplifier (LNA) amplifier stages. The effect of the complex zero in the Z₁₁ response on the in-band gain ripple is shown to be alleviated merely by lowering the quality factor of the transformer's secondary coil; this strongly motivates the use of compact, nested-inductor transformer layouts. Implemented in a 65-nm CMOS process, a three-stage LNA (with Z₁₁ wideband loads in two stages) achieves a 24.4-32.3-GHz bandwidth (27.9 % fractional bandwidth), a peak S₂₁ of 24.4 dB (20.4 dB), a minimum noise figure (NF) of 4 dB (4.6 dB), and an input-referred P1dB of -23 dBm (-22 dBm) while consuming 22-mW (9.9 mW) power from a 1.1-V (0.85 V) supply. The use of compact transformers limits the LNA's footprint to only 0.12 mm². A 26.5-32.5-GHz quadrature receiver prototype employing the LNA achieves a 29.5-dB peak conversion gain, a 5.3-dB minimum NF, and a -26-dBm input-referred P1dB while consuming 33 mW from a 1.1-V supply.Keywords
Funding Information
- National Science Foundation (EECS-1343324, CCF-1314876)
This publication has 32 references indexed in Scilit:
- Design of Wideband LNA Employing Cascaded Complimentary Common Gate and Common Source StagesIEEE Microwave and Wireless Components Letters, 2017
- On the Design of Wideband Transformer-Based Fourth Order Matching Networks for ${E}$ -Band Receivers in 28-nm CMOSIEEE Journal of Solid-State Circuits, 2017
- A 42mW 26–28 GHz phased-array receive channel with 12 dB gain, 4 dB NF and 0 dBm IIP3 in 45nm CMOS SOI2016
- An Overview of Signal Processing Techniques for Millimeter Wave MIMO SystemsIEEE Journal of Selected Topics in Signal Processing, 2016
- An Ultra-Wideband IF Millimeter-Wave Receiver With a 20 GHz Channel Bandwidth Using Gain-Equalized TransformersIEEE Journal of Solid-State Circuits, 2016
- A Transformer-neutralized 0.6 V V DD 17–29 GHz LNA and its application to an RF front-endAnalog Integrated Circuits and Signal Processing, 2015
- A Compact, Supply-Voltage Scalable 45–66 GHz Baseband-Combining CMOS Phased-Array ReceiverIEEE Journal of Solid-State Circuits, 2014
- A 60 GHz Drain-Source Neutralized Wideband Linear Power Amplifier in 28 nm CMOSIEEE Transactions on Circuits and Systems I: Regular Papers, 2014
- A 2.9-dB noise figure, Q-band millimeter-wave CMOS SOI LNA2011
- Analysis and Design of a 1.6–28-GHz Compact Wideband LNA in 90-nm CMOS Using a $ \pi $-Match Input NetworkIEEE Transactions on Microwave Theory and Techniques, 2010