Rate‐Dependent Mechanical Behavior and Amorphization of Ultrafine‐Grained Boron Carbide
- 16 June 2016
- journal article
- research article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 99 (10) , 3398-3405
Abstract
An investigation into mechanical properties and amorphization behavior of ultrafine‐grained (0.3 μm) boron carbide (B 4 C) is conducted and compared to a baseline coarse‐grained (10 μm) boron carbide. Static and dynamic uniaxial compressive strength, and static and dynamic Vickers indentation hardness were determined, and Raman spectroscopy was then conducted on indented regions to quantify and compare the intensity of amorphization. In relation to coarse‐grained B 4 C the ultrafine‐grained material exhibited, on average, a 33% higher static compressive strength, 20% higher dynamic compressive strength, 10% higher static Vickers hardness, and 23% higher dynamic Vickers hardness. In addition, there was an 18% reduction in indentation‐induced radial crack length in ultrafine‐grained B 4 C, which corresponded to an increase in estimated fracture toughness. Although traditional coarse‐grained B 4 C exhibits an 8.6% decrease in hardness from the static to dynamic regimes, ultrafine‐grained B 4 C showed only negligible change under similar conditions, suggesting a reduced propensity for amorphization. Raman spectroscopic analysis confirmed this result by revealing significantly lower amorphization intensity in ultrafine‐B 4 C compared to coarse‐grained B 4 C. These results may have significant positive implications in the implementation of ultrafine‐grained boron carbide as a material for improved performance in impact and other high‐pressure applications.Keywords
Funding Information
- Army Research Office (W911NF‐14‐1‐0230)
This publication has 39 references indexed in Scilit:
- Influence of stress state and strain rate on structural amorphization in boron carbideJournal of Applied Physics, 2012
- Rate‐Dependent Indentation Response of Structural CeramicsJournal of the American Ceramic Society, 2010
- Microstructural characterization of spark plasma sintered boron carbide ceramicsCeramics International, 2010
- Dynamic Indentation Response of Fine‐Grained Boron CarbideJournal of the American Ceramic Society, 2007
- Mechanical properties of nanocrystalline materialsProgress in Materials Science, 2006
- Nanomaterials – the driving forceMaterials Today, 2004
- Densification and Mechanical Properties of B4C with Al2O3 as a Sintering AidJournal of the American Ceramic Society, 2000
- On hardness and toughness of ultrafine and nanocrystalline hard materialsInternational Journal of Refractory Metals and Hard Materials, 1999
- Critical Appraisal of Limiting Strain Rates for Compression Testing of Ceramics in a Split Hopkinson Pressure BarJournal of the American Ceramic Society, 1994
- A Critical Evaluation of Indentation Techniques for Measuring Fracture Toughness: I, Direct Crack MeasurementsJournal of the American Ceramic Society, 1981