Influence of pre-existing damages on the degradation behavior of crystalline silicon photovoltaic modules
Authors:
- 1 March 2018
- journal article
- conference paper
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 10 (2) , 021004
Abstract
In this paper, the influence of pre-existing crystalline damage, such as cracked or broken cells or soldering failures, as they are frequently observed in operating photovoltaic (PV) plants, on the degradation behavior of mono- and polycrystalline silicon PV modules is investigated. In particular, it is analyzed if and to what extent pre-damage introduced prior to lamination propagates upon stress exposure. Therefore, the pre-damaged modules are exposed to various accelerated aging conditions in order to analyze the impact of the pre-damage on the degradation behavior under the respective aging scenario. In order to separate the influence of the pre-damage from composition-induced influences, the choice of materials used in the modules is varied. These investigations reveal that none of the accelerated aging tests causes any change in the pre-existing damage. In fact, the degradation behavior and rate rather depended on the choice of the module components than on the nature of the pre-damage. Finally, these results are compared with indoor and outdoor results obtained from other studies.Keywords
Funding Information
- Free State of Bavaria
- European Regional Development Fund
This publication has 14 references indexed in Scilit:
- Impact of transportation on silicon wafer-based photovoltaic modulesProgress in Photovoltaics: Research and Applications, 2016
- Controlled Introduction of Cracks into Crystalline Silicon Solar Cells and Subsequent Acoustic ExcitationEnergy Procedia, 2015
- Degradation by acetic acid for crystalline Si photovoltaic modulesJapanese Journal of Applied Physics, 2015
- Investigation of Acetic Acid Corrosion Impact on Printed Solar Cell ContactsIEEE Journal of Photovoltaics, 2015
- Fatigue degradation and electric recovery in Silicon solar cells embedded in photovoltaic modulesScientific Reports, 2014
- Damp heat versus field reliability for crystalline silicon2012
- Criticality of Cracks in PV ModulesEnergy Procedia, 2012
- Impact of Micro-Cracks on the Degradation of Solar Cell Performance Based On Two-Diode Model ParametersEnergy Procedia, 2012
- Analysis of stresses and breakage of crystalline silicon wafers during handling and transportSolar Energy Materials and Solar Cells, 2009
- Modeling of rates of moisture ingress into photovoltaic modulesSolar Energy Materials and Solar Cells, 2006