The Effect of Triangle-Shaped Surface Textures on the Performance of the Lubricated Point-Contacts
Authors:
- Wen-Zhong WangWWWen-Zhong Wang
- Zhixiang HuangZHZhixiang Huang
- Dian ShenDSDian Shen
- Lingjia KongLKLingjia Kong
- 18 March 2013
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 135 (2) , 021503
Abstract
It has been recognized that purposefully designed surface texturing can contribute to the improvement of tribological performance of elements and friction reduction. However, its optimal parameters may depend on the operating conditions. This paper investigated the effect of a triangle-shaped dimples array on the tribological performance of the lubricated point-contacts under different lubrication regimes, based on the rotational sliding experiment of a patterned steel disk against smooth steel balls. The dimples arrays were produced by laser process and characterized by the 3D profilometer. A series of tests were conducted with different dimple parameters including depth, coverage ratio, size, and direction. Stribecklike curves were obtained to depict the transition of lubrication regimes, and the electrical contact resistance was utilized to qualitatively characterize the lubrication status. The test results showed that the dimples arrays with different sizes, depths and coverage ratios had a distinct effect on the friction behaviors. Compared with the nontextured surfaces, when the dimple depth decreased from 30μm to zero with fixed coverage ratio and size, the friction coefficient firstly decreased, and then increased. The friction coefficient finally approached that of the nontextured surface, during which the lowest value appeared at the dimple depth of approximately 10∼15μm. The coverage ratio of texture showed the similar effect on the friction coefficient. Usually, the coverage ratio of approximately 10% resulted in the lowest friction coefficient. The dimple size and direction also had obvious effects on the friction coefficient. Thus, it can be concluded that there exists a set of optimal values for the dimple depth, coverage ratio, size, and direction to realize the friction reduction.Keywords
This publication has 27 references indexed in Scilit:
- Rolling Contact Fatigue Performance of Vibro-Mechanical Textured SurfacesTribology Transactions, 2010
- Model-based virtual surface texturing for concentrated conformal-contact lubricationProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2010
- On some aspects of numerical solutions of thin-film and mixed elastohydrodynamic lubricationProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2007
- Effect of Deterministic Asperity Geometry on Hydrodynamic LubricationJournal of Tribology, 2004
- Surface Feature Effects in Starved Circular EHL ContactsJournal of Tribology, 2001
- A Full Numerical Solution to the Mixed Lubrication in Point ContactsJournal of Tribology, 1999
- Analytical and Experimental Investigation of Laser-Textured Mechanical Seal FacesTribology Transactions, 1999
- Impact of Plateaued Surfaces on Tribological PerformanceTribology Transactions, 1996
- A new laser texturing technique for high performance magnetic disk drivesIEEE Transactions on Magnetics, 1995
- A Theory of Lubrication by MicroirregularitiesJournal of Basic Engineering, 1966