Intake O 2 Concentration Estimation in a Turbocharged Diesel Engine through NOE
- 27 September 2020
- journal article
- research article
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 03 (2) , 864-871
Abstract
Diesel engines with their embedded control systems are becoming increasingly complex as the emission regulations tighten, especially concerning NOx pollutants. The combustion and emission formation processes are closely correlated to the intake manifold O2 concentration. Consequently, the performance of the engine controllers can be improved if a model-based or sensor-based estimation of the O2 concentration is available. The paper addresses the modeling of the O2 concentration in a turbocharged diesel engine. Dynamic models, compared to generally employed steady state maps, capture the dynamic effects occurring over transients, when the major deviations from the stationary maps are found. Dynamic models positively affect the control system making it more effective and, exploiting information coming from sensors, they provide a more robust prediction performance. Firstly, a Nonlinear Output Error model (NOE), with simulation focus, fed with four inputs is presented. The considered nonlinear function set is the one of neural networks. The inputs are engine BMEP, engine RPM and EGR and VGT valves position. Two distinct datasets are used for training and validation of the NOE model. These sets are generated using GT-Power simulation software implementing a fine model of the engine, previously validated on experimental measurements taken on the real engine. Besides the transient validation, the NOE model was tested against GT-Power outputs on step tests involving the EGR and VGT actuators. At last the network output is compared with an O2 steady state map over a transient in normal and faulty conditions. The performance of the model is satisfactory in both conditions. Secondly, the potential benefits of installing an O2 sensor in the intake manifold is presented: a Nonlinear Auto-Regressive with eXogenous input (NARX) model is considered and compared to the previously investigated NOE. The results prove that, exploiting the output coming from the O2 sensor, the model prediction capability significantly improves.Keywords
This publication has 16 references indexed in Scilit:
- New Methodology for the Identification of the Leakage Paths and Guidelines for the Design of Common Rail Injectors With Reduced LeakageJournal of Engineering for Gas Turbines and Power, 2017
- Estimation of Intake Oxygen Concentration Using a Dynamic Correction State With Extended Kalman Filter for Light-Duty Diesel EnginesJournal of Dynamic Systems, Measurement, and Control, 2017
- Hydraulic Characterization of Solenoid-actuated Injectors for Diesel Engine Common Rail SystemsEnergy Procedia, 2016
- Comparison between Internal and External EGR Performance on a Heavy Duty Diesel Engine by Means of a Refined 1D Fluid-Dynamic Engine ModelSAE International Journal of Engines, 2015
- Real-Time Estimation of Intake O 2 Concentration in Turbocharged Common-Rail Diesel EnginesSAE International Journal of Engines, 2013
- Real-Time Calculation of EGR Rate and Intake Charge Oxygen Concentration for Misfire Detection in Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 2011
- In-cylinder oxygen concentration estimation for diesel engines via transport delay modeling2011
- Common Rail without Accumulator: Development, Theoretical-Experimental Analysis and Performance Enhancement at DI-HCCI Level of a New Generation FISSAE International Journal of Advances and Current Practices in Mobility, 2007
- High-Pressure Rotary Pump Performance in Multi-Jet Common Rail Systems2006
- NNSYSID and NNCTRL - MATLAB Tools for System Identification and Control with Neural NetworksIFAC Proceedings Volumes, 1997