Synthesis of a Starchy Photosensitive Material for Additive Manufacturing of Composites Using Digital Light Processing
Open Access
Abstract
In this study, digital light processing (DLP) was used to achieve 3D-printed composite materials containing photosensitive resin blended with starch and hemp fibers. The synthesis of 3D-printed composites was performed without heating, according to various material combinations ranging from pure photosensitive resin to a mixture of three phases, including resin, starch, and hemp fibers, with the weight content for each reinforcing phase reaching up to a third of the formulation. The morphology, composition, and structure of the 3D-printed composites were assessed using infrared spectroscopy, laser granulometry, X-ray diffraction, and optical and scanning electron microscopy. In addition, thermal behavior and mechanical performance were studied using calorimetry, differential scanning calorimetry, and tensile testing combined with high-speed optical imaging. The results showed that the post-curing step is a leading factor for improving the mechanical performance of the 3D-printed composites. In addition, hemp fiber or starch did not alter the tensile strength. However, the largest reinforcing effect in terms of stiffness improvement was obtained with starch. Additionally, starchy composites demonstrated the strongest dependence of heat capacity on operating temperature.Keywords
Funding Information
- FEDER through the INTERREG VA FCE Program, FLOWER project (23)
This publication has 37 references indexed in Scilit:
- Effect of calcined nanoclay on microstructural and mechanical properties of chemically treated hemp fabric-reinforced cement nanocompositesConstruction and Building Materials, 2015
- Challenges of additive manufacturing technologies from an optimisation perspectiveInternational Journal for Simulation and Multidisciplinary Design Optimization, 2015
- Properties Characterization of Chemically Modified Hemp HurdsMaterials, 2014
- Making sense of 3-D printing: Creating a map of additive manufacturing products and servicesAdditive Manufacturing, 2014
- Preparation and Characterization of Three Different Derivatized Potato StarchesJournal of Polymers and the Environment, 2012
- Starch gelatinization using sodium silicate: FTIR, DSC, XRPD, and NMR studiesStarch - Stärke, 2012
- Physicochemical and Binder Properties of Starch Obtained from Cyperus esculentusAAPS PharmSciTech, 2012
- AMYLOSE/AMYLOPECTIN SIMPLE DETERMINATION IN ACID HYDROLYZED TAPIOCA STARCHJournal of the Chilean Chemical Society, 2008
- Thermal analysis of the influence of water content on glass transitionsJournal of Thermal Analysis and Calorimetry, 2008
- Experimental and numerical investigations on microstereolithography of ceramicsJournal of Applied Physics, 2002