The use of multi-variate models for the prediction of heat transfer in vehicle exhaust systems
Authors:
- 17 December 2009
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 224 (3) , 369-385
Abstract
This paper describes the development of an exhaust system model based on the characterization of heat transfer in a series of 11 test sections designed to represent a range of configurations seen in production exhaust systems. These sections include variations in the wall thickness, diameter, bend angle, and radius. This work is part of a larger activity aimed at the accurate modelling of heat transfer and subsequent catalyst light-off in production exhaust systems consisting of similar geometries. For each section a range of steady state tests was performed on a dynamic test cell using a port injected gasoline engine. In each case a correlation between the observed Reynolds number Re and the Nusselt number Nu was developed. A model of the system was implemented in MATLAB—Simulink in which each pipe element was split into 25 subelements by dividing the pipe into five, both axially and radially. After each individual section had been characterized, a generic model was built that was capable of determining the relationship between the Nusselt number and the Reynolds number for previously unseen pipe geometries. Complex exhaust systems can be constructed from smaller elements of defined geometry. The modelling approach was validated using experimental data gathered from vehicle testing on a chassis dynamometer. The steady state relationship between Re and Nu allows heat transfer in the test section to be predicted over transient test cycles and demonstrates good agreement with relationships in the literature.Keywords
This publication has 8 references indexed in Scilit:
- Sensitivity Analysis of a Diesel Exhaust System Thermal ModelSAE International Journal of Advances and Current Practices in Mobility, 2004
- Mean Value Models for Exhaust System TemperaturesSAE International Journal of Advances and Current Practices in Mobility, 2002
- A Modular Numerical Simulation Tool Predicting Catalytic Converter Light-Off by Improved Modeling of Thermal Management and Conversion CharacteristicsSAE International Journal of Advances and Current Practices in Mobility, 2001
- Exhaust System Heat Transfer and Catalytic Converter PerformanceSAE International Journal of Advances and Current Practices in Mobility, 1999
- Transient heat transfer modelling in automotive exhaust systemsProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 1997
- Automobile Exhaust-System Steady-State Heat TransferSAE International Journal of Advances and Current Practices in Mobility, 1993
- Heat Transfer in the Straight Section of an Exhaust Port of a Spark Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 1979
- Heat Transfer and Pressure Drop of Liquids in TubesIndustrial & Engineering Chemistry, 1936