A comprehensive experimental and numerical study of foldover onset and growth during the barrelling compression test
Authors:
Open Access
- 22 December 2022
- journal article
- review article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 14 (12)
Abstract
Foldover is a common, yet complex, transient boundary condition in several ‘metal forming processes’ including the barrelling compression test (BCT). The onset of foldover during BCT is comparable to that of necking in the tensile test. However, its role in flow curve identification has been ignored in the current literature. Methods to detect and measure its onset and growth during the processes are also not available. We propose three methods to identify the onset of foldover and measure its progress with deformation. These are conducted together with case studies of BCT to have a fundamental understanding of the onset and growth of foldover in the test and more general cases. Experimental and numerical methods are developed to accomplish this based on (1) direct measurement using tracing points, (2) energy-based and (3) geometry-based indirect measurements. These outline the required supplementary data and allow proper detection of the onset. In the first method, the migration of tracing points from the free surface to the platen-sample interface, simulated numerically, is monitored and measured visually. The second method employs the load-stroke data to calculate the total power input to the deforming system. In the third method, a criterion has been derived to detect the onset of foldover by monitoring the geometry of the sample profile during the test and comparing it to a reference quadratic profile. The observations and outputs of each method are compared and discussed.Keywords
This publication has 23 references indexed in Scilit:
- A note on “Barrel Compression Test”: A method for evaluation of frictionComputational Materials Science, 2010
- An investigation on the variation of surface areas in upsetting of cylindrical specimenIndustrial Lubrication and Tribology, 2005
- An assessment of the interface friction factor using the geometry of upset specimensModelling and Simulation in Materials Science and Engineering, 2005
- A new method for evaluation of friction in bulk metal formingJournal of Materials Processing Technology, 2004
- Prediction of fold defect in barreling formations of cylinder upsettingFinite Elements in Analysis and Design, 2003
- Friction-reducing contact area expansion in upsettingProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2001
- Bulging and folding-over in plane-strain upset forgingJournal of Materials Processing Technology, 1992
- An Approximate Model to Calculate Foldover and Strains During Cold Upsetting of Cylinders Part II: Use of the Foldover Model to Estimate FrictionJournal of Engineering for Industry, 1990
- Disk and Strip Forging with Side Surface Foldover—Part 2: Evaluation of the Upper-Bound SolutionsJournal of Engineering for Industry, 1978
- Disk and Strip Forging with Side-surface Foldover—Part 1: Velocity Field and Upper-Bound AnalysisJournal of Engineering for Industry, 1978