Non-monotonic strength in WAAM Al-Zn-Mg-Cu alloy under transient thermal cycling: Microstructural origins and role of arc energy

Authors:

Abstract
Wire arc additive manufacturing (WAAM) of high-strength Al-Zn-Mg-Cu alloys involves complex transient thermal cycles that alter the balance among strengthening mechanisms, thereby affecting mechanical properties. Herein, Al-Zn-Mg-Cu thin walls were fabricated at arc energies of 76.8, 89.6, and 107.5 J mm-1 to investigate how thermal input influences the competition among strengthening mechanisms. The deposits consisted of an α-Al matrix with η phase precipitates. The tensile response was non-monotonic: the wall fabricated at 89.6 J mm-1 exhibited the highest yield strength in both the horizontal and vertical directions despite having the largest average grain size (131.3 μm). The corresponding ultimate tensile strengths and elongations in the horizontal and vertical directions were 251 and 208 MPa and 3.6% and 2.0%, respectively. With increasing arc energy, cellular/dendritic structures and η phase precipitates coarsened, while the local solute concentration in the α-Al matrix decreased. The wall fabricated at 89.6 J mm-1 exhibited the highest KAM and contained dispersed intragranular equilibrium η precipitates. An incoherent η/α-Al interface and a coherent η/η boundary inside the grain-boundary η precipitate were also identified in this wall. These observations suggest that enhanced dislocation strengthening and particle strengthening likely compensate for the reduced grain-boundary and solid-solution strengthening contributions. Among the investigated conditions, 89.6 J mm-1 provided a favorable combination of strength and ductility.

This publication has 24 references indexed in Scilit: