High-Speed Flow and Combustion Visualization to Study the Effects of Charge Motion Control on Fuel Spray Development and Combustion Inside a Direct-Injection Spark-Ignition Engine
Authors:
- 12 April 2011
- journal article
- Published by SAE International in SAE International Journal of Engines
- Vol. 04 (1) , 1469-1480
Abstract
An experimental study is performed to investigate the effects of charge motion control on in-cylinder fuel-air mixture preparation and combustion inside a direct-injection spark-ignition engine with optical access to the cylinder. High-pressure production injector is used with fuel pressures of 5 and 10 MPa. Three different geometries of charge motion control (CMC) device are considered; two are expected to enhance the swirl motion inside the engine cylinder whereas the third one is expected to enhance the tumble motion. Experiments are performed at 1500 rpm engine speed with the variation in fuel injection timing, fuel pressure and the number of injections. It is found that swirl-type CMC devices significantly enhance the fuel-air mixing inside the engine cylinder with slower spray tip penetration than that of the baseline case without CMC device. Combustion images show that the flame growth is faster with CMC device compared to the similar case without CMC device.Keywords
This publication has 9 references indexed in Scilit:
- A Study of Fuel Impingement Analysis on In-Cylinder Surfaces in a Direct-Injection Spark-Ignition Engine with Gasoline and Ethanol-Gasoline Blended FuelsSAE International Journal of Advances and Current Practices in Mobility, 2010
- A Study of Cycle-to-Cycle Variations and the Influence of Charge Motion Control on In-Cylinder Flow in an IC EngineJournal of Fluids Engineering, 2010
- Fast mass-fraction-burned calculation using the net pressure method for real-time applicationsProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2009
- An Optical Study of Spray Development and Combustion of Ethanol, Iso-Octane and Gasoline Blends in a DISI EngineSAE International Journal of Advances and Current Practices in Mobility, 2008
- A High Speed Flow Visualization Study of Fuel Spray Pattern Effect on Mixture Formation in a Low Pressure Direct Injection Gasoline EngineSAE International Journal of Advances and Current Practices in Mobility, 2007
- Effects of Charge Motion Control During Cold Start of SI EnginesSAE International Journal of Advances and Current Practices in Mobility, 2006
- Effects of Injection Timings and Intake Port Flow Control on the In-Cylinder Wetted Fuel Footprints during PFI Engine Startup ProcessSAE International Journal of Advances and Current Practices in Mobility, 2005
- Effect of the Swirl Control Valve on the In-Cylinder Air Motion in a Four-Valve SI EngineSAE International Journal of Advances and Current Practices in Mobility, 2000
- Motion Pictures of Engine Flames Correlated with Pressure CardsSAE International Journal of Advances and Current Practices in Mobility, 1938